1995 cutlass supreme head gasked replacement. Chilton's is pretty vauge on details. Never done this before (6 cylinder 3.1). Only on a 4 cylinder 2.2. Chiton's instructs to remove engine struts and to rotate the engine and I don't have and engine hoist. Is it possible to get around this. Also any tips on radiator replacement would be great. Is it possible it could just be the radiator and the head and headgaskets are fine? Your help would be greatly appreciated. Thank you for your time.

Did you replace the fuel filter as well as the oil filter ?. If there is a good spark at the plugs it has to be a fuel problem . Check the fuel pressure and flow the flow is most important. if the pressure is high the regulator on the fuel rail may be stuck shut . and there will be no flow on the return line.

it either has a cylinder misfire or is running lean. Sometimes the air flow sensor gets a varnish coating on the heated wires and needs to be cleaned with spray carb cleaner

For the 1992 Oldsmobile Cutlass Supreme 3.1L DOHC V6

Firing Order:
1 - 2 - 3 - 4 - 5 - 6

Cylinders:
.......(back)......
|...1....3....5...|
|...................|
|...2....4....6...|
.......(front)

Coil Connections:
..................................
.|.1..4.|...|.3..6.|...|.2..5.|

Let me know if that helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

For the 1995 Oldsmobile Cutlass Supreme:
I do not know if you have the 3.1L V6 or the 3.4L DOHC V6; however below are included below:

For the 3.1L V6:
Firing Order:
1-2-3-4-5-6
Cylinders:
........(back)........
|...1......3.......5...|
..........................
|...2.......4......6...|
.........(front)
Ignition Coil Connections:
...........(back)
.|5..2.|..|.3..6.|..|.4..1.|
...........(front)

For the 3.4L DOHC V6:
Firing Order:
1-2-3-4-5-6
Cylinders:
.........(back).........
|...1.......3.......5...|
...........................
|...2.......4.......6...|
..........(front)
Ignition Coils Connections:
..........(back)
.|.1..4.|.|.3..6.|.|.2..5.| (Honestly: I'm thinking it should be 6..3 not 3..6)
..........(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

For 1995 Oldsmobile Cutlass Supreme 3.1 liter V-6 VIN "M" check...



Hope help (remember rated this).

use 3/16 brake line, thats what i use and ive done a ton of those, your going to need a flare kit or bouble flare kit depending on what type you have, good luck.

To be 100% sure it is 1-2-3-4-5-6. Your number one Cylinder is located on the backside of the engine (closest to the windshield) on the Passenger (aka right) side of the engine. Number two is located on the front of the enging (closest to the bumper)farthest right (passenger side). So the cylinder numbers on the back of the engine are 1-3-5 and the cylinders on the front of the vehicle are 2-4-6.

You may have pulled the inner tri-pod joint out of the cv shaft and that will make noise. Is the bearing really bad? Does it turn freely?

Head Bolt Torque For your 1994 Oldsmobile Cutlass Supreme (3.4L SFI DOHC): Foot pounds (Final torque) Note: Torque sequence --------- | 6 2 3 7 | | 5 1 4 8 | --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque. Foot pounds (Final torque) Note: Torque sequence --------- | 8 4 1 5 | | 7 3 2 6 | front --------- of engine | 6 2 3 7 | | 5 1 4 8 | Step 1: torque to 40 Ft/Lbs --------- Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION ***engine uses Torque To Yield head bolts (TTY) thatpermanently stretch during the initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque.

Never Never Do this! Just buy a brand new one there is too much at risk sorry never play with brakes just for money. No rebuilt either only bran new will do.