2006 Audi A4 keyless entry programing instructions

That isn't how it works, you must have the dealer reprogram the whole system to correct this if the loss of program is the cause. You can't do it at home it requires a special tool to go int the control modules programing option.

You can't program this, the dealer has to do it with a scanner to enter programming mode to accept the key fob signal

some remotes there is a tab you slide and a key pops out for the drivers door incase your battery dies. check if yours does this otherwise it looks like a trip to your Audi dealer for a new remote of if your lucky you can find a used one and programming instructions for it but then your left with the problem of getting the doors open to get in and program it with a key.

I recently picked up an 2001 Audi and the dealer told me that this is one of the most common questions. You have to double press the unlock button of your keyless entry pad to unlock all doors including the fuel access door. Perhaps you are checking the fuel access door while all doors are unlocked?

Open remote clean contacts w/alcohol get the correct battery--or go back to the owner -bull

Instructions to program a keyless entry remote for a Chevy Silverado. They also work on 2003, 2004 and 2006 Suburbans.

1. Close all the vehicle doors.
2. Insert the ignition key into the ignition lock cylinder.
3. Press and hold the DOOR unlock switch.
4. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
5. Release the DOOR unlock switch. The doors will lock and unlock to confirm the program mode.
6. Press and hold the LOCK button and the UNLOCK button simultaneously on one keyless remote. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to four transmitters.
8. Turn the ignition switch to the RUN (one more click forward) position in order to exit the keyless entry transmitter mode.
9. Operate the transmitter functions in order to verify correct system operation

Hi, I had the same problem. It turns out to be the vacuum pump's impellar. You cant buy it loose - have to buy the whole unit.

Try taking the car to an Audi dealer to reprogram the key.In some cases,depending on the country it was imported from ,it may take several attempts at programming to get it right.Your Audi dealer should do this at no charge.As for removing the battery,always clamp an alternate 12v source to the car cables so the vehicle does not lose a 12v source when changing batteries.These are complicated cars.You need to recode some systems after total loss of 12v.Once again the dealers will help.
Cheers

You Need Vas5051 Or Vag-com Equipment To Programe It

It's doubtful, but your best bet would be to consult with a dealer of Mongoose products, an independent stereo shop, or search the various Audi owners' forums (www.audiforums.com, www.audizine.com, etc) - chances are someone there has a similar system and may be able to help you out.