Suddenly had no acceleration, check engine light

P228C, it has applied exclusively to diesel powered vehicles. It has also meant that the powertrain control module (PCM) had detected a low voltage signal from the control circuit of the electronic fuel pressure regulator, which reflected insufficient fuel pressure.

Read more at: https://www.obd-codes.com/p228c
Copyright OBD-Codes.com

fuel filter needs replaced or fuel pump

Is the check engine light lit ? Or any other warning lights ? How many miles on the vehicle , has it been well maintained ? Clogged catalytic converter will cause a no power problem . Is there a yellow wrench symbol lit on the instrument cluster .

It sounds like a Mass Air Flow sensor or a Throttle Position sensor.BUT you will have to get a scan and find out what the check engine light is all about and related engine codes to attempt to fix this. This would be my first step. Good luck

Make sure that the gas cap is seated properly and screwed all the way on. Some autos can detect tank pressure, and if it is low, the warning light comes on.

Engine warning light

Illuminates when the ignition is switched on. It should extinguish as soon as the engine starts.
If it illuminates with the engine running, it indicates a malfunction with the engine management system. Have this checked as soon as possible.
If it flashes when driving, reduce the vehicle speed immediately until the light illuminates constantly. If it continues to flash, avoid heavy acceleration and high engine speed, stop the vehicle and have it checked immediately.
On some vehicles this light may be red - again stop the vehicle and seek assistance.
If it is safe to do so, try stopping the vehicle, switching off the engine, wait two minutes, then restarting the engine to reset the engine management system.
With the light illuminated, the vehicle is still safe to drive as long as no other faults are apparent with the engine. Have the vehicle checked by a dealer or garage as soon as possible to avoid any damage being caused to the catalytic converter

i had a problem with all my lights coming on in my 2006 explore took it to dealer to find out that the battery was dying replaced it and they went away

whats a vsa warning light not sure my lx has on :{

I don't know about hybrids, but on most vechiles, you check power steering fluid with engine running.

have a mechanic check out the engine main bearings,or see if the torque converter has came loose from the flywheel