1997 Mercedes-Benz C-Class Logo
Posted on Aug 28, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Dear, i have a mercedes 230 c (1997) with american options... the internal light has just swiched off and it is unable to be lighted again...it must light when open any door, or pressing the light button inside the cabin .. or when i open the car using the remote... i have checked the fuse set.. they are all working... could you please advise me how to check the problem? ... noting that the light was been working since 1 week only !

  • swessmass Aug 29, 2009

    dear...i have checked the same... but nothing is wrong...
    something i would like to bring to your notice...
    when you are connecting any lamp to the battery... you must have + & - lines...
    in my case... i am checking the two lines... and both of them are +
    i mean that the lamp is getting two + lines, that's why it is not working...

×

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Sergeant:

An expert that has over 500 points.

  • Expert 408 Answers
  • Posted on Aug 29, 2009
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Sergeant:

An expert that has over 500 points.

Joined: Mar 19, 2009
Answers
408
Questions
0
Helped
227722
Points
940

Hello,good day,fuse is ok as you check,try to check your bulb,your door switch need also tobe check or try to remove the cover of your internal or dome light,try to check the electrical connection,battery voltage and ground supply should be present when your door is open,if not,check wiring for continuity,ty

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Stop lights and cruze quick on my 1993 gmc

The brake light circuit runs through the signal light switch. Possible signal light switch internal failure. The cruise uses the brake light circuit as well to disengage
0helpful
1answer

I have a mercedes ml 270 cdi 2002 and when I move off from a stand still I get the dash lit up like a Christmas tree with abs/epc/bas and warning triangle along with brake light and goes into limp mode, I...

Sounds like you have a speed sensor problem. Possibly input or output shaft speed sensor on transmission. You will need to find out what fault codes are being set and proceed from there.
0helpful
2answers

2009 c-class auto stalling when stopping?

Throttle sensor on the engine is the only thing that would cause this to happen.Have it checked or do a diagnostic yourself with a code tester.Get the code and look in your manual for that code.The engine management/check engine light will always come on after a stall when swich is still on.Comes on when you turn the swich on at startup also does it not.Computers ya know.
0helpful
1answer

My Electronic Ignition Switch of model E-230,1997 is damaged please tell me the price of new Igntion switch

Over the internet you can get an ignition switch for your vehicle from $23 to $50.00 depending on where you buy from. If you go to the dealer add three times that much onto the price.
1helpful
2answers
15helpful
3answers

My Mercedes ML 270 cdi ABS etc lights and gearbox.

  • you need a Brake safety switch replaced.This is located behind you brake pedal.it's a common problem. The warning lights will reset after a few engine starts.
0helpful
1answer

Mercedes ignition swich barrel dropped cannot move pin

hi,you can drill the release pin to remove the steering cylinder,ty
0helpful
1answer

Unable to unlacht divers door

try to remove the door panel,might be the micro switch for alarm is stock,or some linkage maybe disconnected to the swich.
Not finding what you are looking for?

131 views

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...