Question about 2002 Subaru Outback

1 Answer

Engine miss on #3 cyl. new plugs,wires, and coilpack

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Check for vaccum leaks, gasket leaks, injector leaks! and test coil packs to see if module is good and you get spark to every cylinder and see if you get fuel to every cylinder.
How many miles do you have? Is the motor tired?

Posted on Aug 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacement Spark Plugs Continually Misfiring for Cyl. #1


Locate the ignition coils - they are mounted on the ignition module. Remove the wide connector that goes to the module. You will have to unscrew it first. Spray some WD40 on the connector pins and try to scrub them with a tip of a small screwdriver. Be delicate not to brake or bend anything. Reconnect the connector. Start the engine and see if it still misses.
If it still does, try to touch/move each of the wires that go to the ignition module. BE VERY CAREFUL not to touch any of the moving parts of the engine as you have to do it with engine running.

If it still misses, do the following.
1. Engine off
2. Mark the ignition wires so that you reconnect them later in the same order
3. Locate the coil which gives spark for cyl 1
4. Switch locations of this coil with any of the two remaining coils
5. Reconnect the wires
6. Start the engine

If it now misses on another cylinder, you will have to buy a new coil.

Dec 05, 2013 | 2002 Buick LeSabre

1 Answer

What would cause a miss in a 5.3 engine


no spark from coilpack bad ignition wire and or spark plug.scan test find which cylinder is missing.there is a service bulletin from g.m. on misfires 5.3L engines.possible carboned buildup piston rings.cylinders walls need to be inspected for abnormal wear.my need new short block.

Jan 20, 2013 | 2000 Chevrolet Silverado 1500

2 Answers

Cyl. 3 miss fire code po303


my money would be on the coil cover, especially if it had been a long time since the last tune up. it is certainly worth trying, as this is part of a routine tune up anyways. good luck!

Mar 18, 2010 | 1999 Pontiac Sunfire

1 Answer

2000 excursion misfire on cyl 4. traded plug,


Remove the plug and check the compression for that cylinder it should be between 120 psi and 150 psi, if it is low it is a mechanical issue (bad valve or worn piston rings). If commpression is low remove the valve cover and turn over the motor confirming that both valves for that cylinder are opening to there correct travel or height if not it is a faulty hydraulic lifter or worn cam. Also check the valve lash clearance the clearance is usually .012" for the exhaust valve and .008" for the intake valve to check the lash turn the motor over until the valve shuts completely for each valve, then use a feeler gauge go no go procedure. Has the wire been replaced for the plug? If this motor has coil on plug type disregard plug wire question.

Jan 05, 2010 | 2000 Ford Excursion

2 Answers

2003 PT Cruiser - check engine light


Use the correct champion plugs for starters, make sure the wire is firing. If the wire is firing, the coil pack is good. You will need to check compression and fuel delivery after that.

Jun 23, 2009 | 2003 Chrysler PT Cruiser

1 Answer

2002 ford ranger 3.0 is missing on 2 cyl plugs ok injectors ok new coilpack


do a compression test,as the intake manifold,like alot of fords is no good.

May 22, 2009 | 2000 Ford Ranger SuperCab

2 Answers

2001 ford taurus p0301 and p0303


You are mis fireing on cyl 1 and 3 if you replaced plugs and wires and coil this is going to be a fuel injector issue or valve issue. See if you can swap the injectors with known good cyl. and see if it changes. Or have a shop do a fuel injector service on it to see if it helps. It may be to late for the fuel injector service.

Mar 01, 2009 | 2001 Ford Taurus

1 Answer

97 dodge neon


make sure your not getting oil down into the holes where plugs go this can mess with the wires.Is it actually skipping?

Sep 10, 2008 | 1997 Dodge Neon

Not finding what you are looking for?
2002 Subaru Outback Logo

Related Topics:

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...