If you have a TPS(throttle position switch) you may bre able to turn the knurled knob at the end downward to speed up . or theres a small hex key fitting in the rear center of the switch with wiich you would screw it in to increase the speed. If you do not have an emmision controlled speed switch(tps) then there is a screw that is capped of and probably shouldn't be moved. Your idle usually drops because of afault in the timing, a vacuum leak or another simple problem.But adjustments to the factory settings are rarely needed, I'd look around a bit before doing this. Good luck.
Depends on what setup you are running. Some 318's had 2bl Holley's...one model had electronic feedback and one did not. There were also different 4bl models depending on if it was a 318 or 360. Given the age of your RC, you might even be running an aftermarket carb and/or intake.
Do a thread search or post a question on the vehicle help board at Ramchargercentral.com...the crew over there will be able to help you with everything from identification of your setup to troubleshooting, adjustment, and repair of your idle issue.
319 views
Usually answered in minutes!
×