Question about 1999 Isuzu Rodeo
If you just had a radio installed and your marker lights are blowing the fuse then whoever installed your radio hooked up the dimmer wire incorrectly, it either needs to be capped off or taped up, it's probably connected to the radio's dimmer input to the wrong polarity
Posted on Feb 19, 2012
Ck to make sure the radio itself is not pinching any wires wiggle the wiring harness around .. a blown fuse is a direct short but also try this disconect one marker lite at a time you could have one bad marker lite causing the problem it could be just a coincidense with the radio installation
Posted on Aug 24, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Mar 17, 2017 | 2002 Isuzu Rodeo
Feb 29, 2016 | 2007 Hyundai Veracruz SE
Mar 02, 2018 | 2009 Saturn VUE
Mar 10, 2013 | Cars & Trucks
Jun 22, 2017 | Cars & Trucks
The tail and marker lights and Instrument lights are on the same circuit so both will go out if the fuse for this circuit blows. If fuse continues to fail, check the tail light or marker globes, including the globes for the number plate, for a globe that may have an internal short causing the fault and replace as necessary. As you have already checked the wiring near the light fittings for any chafed wires that could be shorting to the body causing the fault, then a closer inspection of the wires inside all the light assemblies for any shorts may be needed.
It could also be that the instrument dimmer control has failed and is causing the fault. The electronic bits inside the dimmer control for these lights sometimes go faulty. Try disconnecting the connecting plug on the rear of the dimmer control and checking if fuse still blows. If fuse continues to fail, then the fault in the tail and marker lights circuit.
Remove all the tail, number plate and running light globes from the light assemblies and leave the instrument dimmer control disconnected and check if fuse still blows.
Disconnect the plug near each of the light assemblies to see if any of the individual assemblies is causing the fault. With all light assemblies disconnected and fuse continues to fail, then the fault must be in the main wiring loom some where.
If you have a Multimeter, it could be used to determine which light assembly has a fault between the lamp supply and earth connection.
Feb 25, 2011 | 1987 Toyota 4Runner
Jul 05, 2010 | 1994 Nissan Pickup
Nov 01, 2009 | 1995 Chevrolet Silverado 2500
Jul 29, 2009 | 2002 Isuzu Rodeo
167 people viewed this question
Usually answered in minutes!