I have a Gmc 1995 safari changed throttle postion sensor,new plugs and wires but engine still will idle faster then normal and picks up speed when driving

HI
first I would like to tell you, do this procedure only if the 5th digit of your VIN is C or K.

Description

The engine control module (ECM) learns the idle position of the throttle plate to ensure the correct idle. Anytime the throttle body is cleaned or replaced, the ECM must learn the new throttle position. The idle may be unstable or a DTC may set if the throttle position is not learned.

Conditions for Running the Throttle Learn Procedure

• DTCs P0101, P0102, P0103, P0107, P0108, P0111, P0112, P0113, P0506, and P0507 are not set.

• The engine speed is between 450-4,000 RPM.

• The manifold absolute pressure (MAP) is greater than 5 kPa.

• The mass air flow (MAF) is greater than 2 g/s.

• The ignition 1 voltage is greater than 10 volts.

Throttle Learn

Important: Do NOT perform this procedure if DTCs are set. Refer to Diagnostic Trouble Code

(DTC) List - Vehicle.

1. Start and idle the engine in PARK for 3 minutes.

2. With a scan tool, monitor desired and actual RPM.

3. The ECM will start to learn the new idle cells and Desired RPM should start to decrease.

4. Ignition OFF for 60 seconds.

5. Start and idle the engine in PARK for 3 minutes.

6. After the 3 minute run time the engine should be idling normal.

Important: During the drive cycle the check engine light may come on with idle speed DTCs. If idle speed codes are set, clear codes so the ECM can continue to learn.

* If the engine idle speed has not been learned the vehicle will need to be driven at

speeds above 70 km/h (44 mph) with several decelerations and extended idles.

7. After the drive cycle, the engine should be idling normally.

* If the engine idle speed has not been learned, turn OFF the ignition for 60 seconds

and repeat step 6.
8. Once the engine speed has returned to normal, clear DTCs.
Good Luck

Check your fuel pressure.l Could be pressure regulator, dirty fuel filter, or weak fuel pump

check the throttle possioning sensor on the throttle body that can cause alot of things

To check EGR valve, plug the vacuum hose to it, and it should not get hot anymore. It if does, it is leaking.
But gas smell is usually bad plug wire or plug.
With good insulation, remove one sparkplug wire at a time, to see if one has no effect. That is the target.

replace the fuel pressure regulator and the fuel filter, the pressure is low.

Is the "service engine" light on at all?
If so, what codes are present.
Have you checked the EGR valve. If the valve is stuck, the engine will idle very poorly. You can remove it and clean the carbon deposites and make sure it moves freely.
The EVAP purge solenoid will also cause an idle problem but should show up as a service engine light problem.
Let me know.
Regards,

the throttle body gasket might be bad causing a vacuum leak.or possible bad idle air control solenoid.in the throttle body.

check for cracked spark plug wires might be shorting out on engine

Idle control sensor on throttle body bad replace it an should work fine

You have a vacuum leak spray either along intake man see if idle speeds up