2005 Acura TSX Logo

Related Topics:

J
Jovanni Garcia Posted on Jul 01, 2019

When I try to put it into reverse, why does the shifter jump out?

Doesn't go into reverse. shifter goes all the way back but doesn't go into gear. Happens all the time now. Whether the vehicle is off or on clutch stepped or not, gear won't go in.

5 Related Answers

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Nov 26, 2008

SOURCE: having trouble shifting gears wont

You need to get to the transmission linkages with some penetrating spray, right where they are attached to transmission at front drivers side. You may have to remove battery & tray to get better access, but 90% of time that's the problem area. You'll see where the shifter linkages attach & pivot on top. The top linkage is your power valve,(like a kickdown) which kicks it down on acceleration, then returns after. This needs to move freely, and it may take some work & spray to get it loosened up, but that should help with your problem, as it affects the shifter itself too. After you get them movong freely, put a good coat of white lithium grease or similar on them . On my 95 neon, i'd have to do it, about once a year or more. Initially it would shift out of lower gear to next at higher revs, and when stopping it would shift down hard. Good Luck

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Nov 30, 2008

SOURCE: Why does my 1993 Acura Integra pop out of 5th gear?

Only 2 thing cause this, worn engagement dogs on the gear pack or worn shifter parts or both, how many miles?

Anonymous

  • 5 Answers
  • Posted on Feb 19, 2009

SOURCE: 1992 Acura Vigor dashboard gear indicator blinks

TRY WHAT THAT OTHER PERSON SAID. IF THAT DOESNT WORK POP UR HOOD OPEN AND SLAM IT DOWN. ONE OF UR SENSORS ARE DIRTY OR LOOSE SAME THING HAPPENS TO MINE.

Anonymous

  • 2 Answers
  • Posted on May 27, 2009

SOURCE: automatic transmission wont catch into any gear

You sould have been moore frequent on your transmission fluid changes, and you shouldn't have taken it to Jiffy Lube either. Your best bet is to drain and fill the trans fluid run it shift gears. Drain and fill again. Do this 3 times. Yeah the transmission fluid is expensive. on the last drain and fill you want to get a bottle of LUBE GUARD from NAPA or who ever sells it. put the whole 10oz bottle in. Shift Rev, 1, 2, 3, D. Neutral Rev D. If that don't work then you have bad seals.

Anonymous

  • 1071 Answers
  • Posted on Jul 25, 2009

SOURCE: 1990 VW cabrio wont reverse. Seems in gear but only goes forward

left and push the shifter into the floor like stabbing down ten it will go left a little more and push forward and you will be on your way in good ol R

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Gear shifter won't shift into reverse or park

When you "muscled it into neural" you broke the shifter. Most likely it will take a replacement shifter to repair.
0helpful
1answer
0helpful
1answer

I got my 2001 dodge ram 1500 with the 5.9L v8 stuck in the sand at the beach. While my buddy was pulling me out from behind, I was flooring it in reverse to get out. Then my my rpm went down and the...

Need more info: is manual shift if so 4sp ,5sp or 6sp speed?
or auto w/overdrive ?
2) wont go into gear or selects reverse gear but acts
like no gear?
3) does forward gears work?
~
4) how's the fluids?
0helpful
1answer

My rebuilt transmission won't go forward?

i would be checking the shifter cable adjustment first see how that goes goodluck
0helpful
1answer

My problem is that the manual transmission is stuck in 4th gear. I was backing up when I went to put it into 1st the shifter was stuck. The clutch works to disengage the gears but the shifter won't...

That cylinder is known as the clutch slave cylinder. It should push against the clutch fork every time the clutch pedal is depressed to allow gear changes. If it doesn't, suspect a faulty slave cylinder, or clutch master cylinder.
0helpful
1answer

1996 Jeep Grand Cherokee. Transmission problems. when the gear selector is in reverse, it doesn't engage in reverse. When you go to neutral, it drives forward but doesn't shift through the...

Put the vehicle in Park, disconnect the shifter from the shift lever on the trans, adjust the linkage or cable so the connection is clearly a slip in/on connection and tighten things back up. Hopefully this will solve your non-reverse. As for all the gunk and metal shavings, friend, you better have another tranny standing by in your garage when this one stops working completely.
0helpful
1answer
0helpful
1answer

2000 Corvette 6 speed with problems going into reverse

i would be temted to say its a worn out linkage
between shifter and transm.
0helpful
1answer

Car stops moving in reverse gear

Sounds like the car is just slipping out of gear. Keep your hand on the shifter when you back up next time. See if you can feel the shifter move when the car comes out of gear. If the shifter moves up when it happens keep pressure on the shifter holding it back like you dont want it to move forward. And of course if the shifter moves back when it comes out of gear, put forward pressure on the shifter so it doesnt slip out. This might work for now but but i know i wouldnt want to spen 700 for that ****. Let me know how it goes.
Not finding what you are looking for?

164 views

Ask a Question

Usually answered in minutes!

Top Acura Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...