Remove driver side headlight assembly 2011 mkx

SOURCE: How do you change the drivers side headlight assembly?

You need to remove the bumper assembly to remove the headlight.

SOURCE: 99 cutlass supreme headlight bulb replacement

Look at the top of the headlight assembly. There is a plastic panel on top of the assembly that is held in place by two plastic pins. Remove those pins by lifting the center of the pin and then pull out the pin. Remove the panel. Then you will find two small plastic levers that will lift about 1/2 inch. They do not come out but they will release two studs that secure the assembly. After the assembly is released, slide it forward to access the bulbs you need to replace. Installation is the reverse of these procedures.

ray calhoun

• 166 Answers
• Posted on Mar 29, 2009

SOURCE: how to remove driver's side mirror assembly and replace

you got to take the door panel off to get to the mirror bolts and wirring i

SOURCE: how do you completely remove the passenger side

Go here for pic by pic instructions

http://forums.vwvortex.com/zerothread?id=1251418

SOURCE: Remove headlight assembly from a 2001 Dodge Ram

On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.