Look into the turn signal switch itself. Have the wiring checked.
SOURCE: Turn signals not working on 2001 Jeep Grand Cherokee
replace the turns signals flasher unit.
SOURCE: 1997 jeep grand cherokee laredo - no turn signals.
Check your fuses the turn signal fuse could be blown.
SOURCE: 1995 Jeep Grand Cherokee Limited - flasher relay location
More than likely you have a bad ground. Under the rear of the vehicle, behind the rear bumper there will be a few wires running to a bolt in the frame (left side i think) Check that no wires are loose or boken. Also if you have a trailer wiring harness, check to see if it has not been damaged. Let me know if this helps :)
SOURCE: my signals and flasher quit working 2002, Jeep
in your vehicles owner manual, look up fuses, and flasher units or flasher relay. Fuses are normally located under the dash, but when both turn signals quit working it is usually the relay. The relay is located under the hood yours owners manual should show you the location.
SOURCE: turn signals hazards flasher don't work jeep
I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING
390 views
Usually answered in minutes!
×