SOURCE: remove the rear bumper
Removing Prowler Rear Bumpers First remove the four 10 MM bolts holding the trans cooler and drop it down. Support it by attaching one bolt to the lower hole on the cooler frame. This will keep the weight off the lines. This takes two min. and allows easy removal of the elect. lines. Then remove the four bolts on each bumper. The bolts are 13MM and 17MM. You will need a ratchet, sockets, extension and a 13MM open end wrench. If you remove the rear bumpers, you should replace the rear pan with one of the aftermarket ones otherwise you will have big holes staring at the people behind you. Go to prowleronline.com and check the vendors for a couple of options. Maybe you are removeing them to paint and reinstall. Look at this link for some options .. Mine is the 7th post down. http://www.prowleronline.com/ubb/Forum1/HTML/014949.html Hope this helps.
SOURCE: Remove rear bumper from 2003 Porche Cayenne
removing takes about 5 minute refiting the back bumper will take about an our to refit the rear bumper if your using power tools
the easiest way to do this is tank some white nail polish mark 3 lines on the mounts on both sides this will give you a guide to placen back the bumper to vehicle
SOURCE: remove rear seat lexus es300 2008
the bottom of the rear seat pulls straight up at the front and out. its pretty tight, you need to pull very firmly.
SOURCE: Volkswagen Passat rear bumper removal
all the screws/bolts are underneath the plastic cover.hex head.(allen key)
380 views
Usually answered in minutes!
×