SOURCE: daewoo nubira transmission control module
Hi, the TCM is located at the passenger side kick panel (LHD), when you remove the kick panel you will see the ECU (engine control module) directly above it is the TCM. I hope this can help.
amf07ph..
SOURCE: Transmission Control Module
Before condemning the transmission, I
would check the shift cable for proper operation. Look at the side of
the transmission where the shift cable attaches. Have someone shift the
transmission from PARK to FIRST. The engine should not be running. If
the operating lever on the transmission moves, then you probably do
have an internal transmission problem.
If the
operating lever does not move, you have a broken shift cable or it has
popped of it's attachments at the operating lever or gear shift handle.
A bad
Transmission Control Module (TCM) would not keep it from shifting. In
the event of a bad TCM, the transmission would go into fail safe mode
and you could continue driving the vehicle.
SOURCE: Needing to locate the airbag control module '07 caliber
it is located behind the floor shifter in center console..under small piece of carpet
SOURCE: programming instructions for 2006 Mitsubishi raider remote
Note when entering program mode using that fob, all other programmed transmitters will be erased and you will have to reprogram them for your vehicle. Use the following procedure to program additional key fobs if the vehicle is not equipped with Sentry Key:
1. Enter your vehicle and close all doors.
2. Fasten yo belt to cancel any chiming that may confuse you
3. Place the key into the ignition turn to on pos. do not start
4. Press and hold the UNLOCK button on the key fob.
5. After holding the UNLOCK button for four seconds, also press the PANIC button within 6 seconds.
6 When a single chime is heard release both buttons. The chime is an indication that you have successfully entered program mode. All transmitters that are to be programmed must be done so within 60 seconds of when the chime was heard.
7. Using the fob to be programmed, press and hold both the LOCK and UNLOCK buttons, simultaneously for 2 seconds and them release.
8. Press and release the UNLOCK button a single chime will be heard,
9 Repeat steps 7 and 8 to program up to six additional transmitters.
10. Turn the ignition to the OFF position.
11. Your vehicle will remain in program mode up to 60 seconds from when the original chime was heard. After 60 Seconds, all programmed transmitters function normally.
SOURCE: where is the transmission control module located i...
where is the transmition control module in galant 2000
1,024 views
Usually answered in minutes!
×