Not the door panels
SOURCE: how to remove interior door panel on a 1997 caravan with ower windowq
Start by removing the negative battery cable from the battery. Then locate and remove the screws that hold the interior door handles in place (they may be hidden by snap in, or snap on covers). Once you have removed the interior door handles, disconnect the wire clips that go to your window and door lock controls.
I personally use a small pry bar to remove the interior door panel; it is held in by plastic snap clips. Try to get as close to, or directly under the snap clips as possible with your pry bar to prevent them from tearing out of the door panel. Once you have released the snap clips, pull the panel upward to remove it. Install in reverse.
I hope this information helps you, and I wish you luck on your repair.
SOURCE: Interior trim panel removal instruction
Normal
0
. Disconnect
your negative battery cable. Locate and remove the screws that hold your
interior door handles in place (they may be hidden by snap in, or snap on
clips). Remove the interior door handles, then disconnect the wire clips to the
switches. Your panel is held in place by snap in clips; use a small pry bar to
pull them from the door (try to get as close to, or directly under the clips to
prevent them from tearing out of the door panel). Once the clips are pulled,
pull the panel upward to remove it from the door.
Install in reverse.
If you don't have power windows you will have to
remove the manual window crank. It is held in place by a clip on the back side
of the base. To remove the clip, you will need a small hook (kind of like a
knitting needle). Put the hook in behind the base, and grab the clip and pull
it off. To replace it, slide the clip back on the window crank, and snap it
back on the door.
SOURCE: Conflicting procedure for removing 2002 Grand Caravan door trim
Chiltons is a very basic manual cover numerous years. To check slighty pry the bottom edge of your door with your fingernails if it is tight all the way to the bottom it probably is the snap fastners. Make sure to remove the door handle bolts/nuts.
SOURCE: remove 2004 Dodge Grand Caravan D-pillar panel
To remove the panel completely. You must remove all screws & the seatbealt bolts for the 2nd & 3rd seats
SOURCE: How to remove and replace
These are generally not for the do it yourselfer since they are spot welded in place and there are many sizes of panels to fit the area you need to replace. Have an auto body shop look at it for advice - many give free estimates.
281 views
Usually answered in minutes!
×