Disconnect negative battery terminal, raise vehicle,remove splash sheild, if equipped. take wires off of solenoid on starter, remove starter mounting bolts, remember not to mix up wires!! --to install--put starter back in vehicle put in bolts,hook up wires, then replace cable back on battery.
How to rewire a starter for a 2003 chevy malibu
SOURCE: wire diagram for a 1998 Chevy Malibu
I have a 98 grand prix has had to starters Battery new cable an still wont start solonid just clicks do it 30 times it will start.
SOURCE: location of the Heat resistor in a 2003 Chevy Malibu?
Under the glove box, behind the blower motor itself. Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.
SOURCE: HOW DO HOME TEST A STARTER ON 2002 CHEVY MALIBU
Remove the starter and jump the connections to a Battery to see if it spins. Make sure you connect positive to the positve end and the neg to the neg end. Hope this helps.
SOURCE: 2003 Chevy malibu electrical schematic Fuel pump
Only if theft light is flashing, then it would need to be reset, to reset turn key to on and wait till theft light stops flashing about 10mim or so, then turn key to off and back to start engine.
3,293 views
Usually answered in minutes!
×