SOURCE: ignition switch fuse terminal is blowing red 40 amp fuse when i try to replace it
A fuse that is consistently blowing is telling you that there is a short in that system. Don't attempt to bridge it or use a larger amp fuse or you will have a major problem. You will need to start tracing wiring to destinations to find the short. If while moving harnesses around problem ceases to exist, look at nearby items where you are working and try to locate what was grounding. Sometimes people will stop if short disappears, leaving open the possibility of it happening again.
If you are not comfortable working with wiring, then leave it to professionals who do this every day. It's not really difficult but requires patience and a good bit of knowledge to do this right!
SOURCE: ignition fuse keeps blowing when i turn the key
It MUST be the starter relay coil - or the power wire that feeds it. Likely a short in the relay coil (AKA starter selenoid).
SOURCE: Key win't turn ignition switch in 2008 Chevy HHR
replace the floor shifter. there is a switch on the shifter that allows the key to move. gm has had alot of problems with these shifters.
SOURCE: 2008 dodge nitro change oil light how to turn off ...
Directions are in the book, but you would put the key in and turn it all the way, just don't start engine. Pump gas pedal all the way to the floor 3 times slowly, but it has to be with 10 seconds. Turn key off and when you start again, oil changed chime and warning should not be on. If it is, try again.
SOURCE: DOES NOT BLOW OUT HOT
take the heater case of ur nitro out and get it checked thoroughly. the issue can be due to various reasons.
220 views
Usually answered in minutes!
×