Chassis is an N38W
Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try
SOURCE: how to change the transmission oil (mitsbishi RVR 1995 auto sport
if it needs changing you should get the bands serviced and get them to do it why do have the job
SOURCE: 2001 mitsubishi eclipse. Automatic transmission
Transmission may be low on transmission fluid or the transmission fluid pump failed. If it's electrical, you can still get it in to gear, but would not shift gears. Good luck and keep me posted, check transmission fluid level and have the transmission line pressure tested. Before that check all your fuses.
SOURCE: Mitsubishi Pajero Junior Automatic Gearbox Problem
I have a pajero junior 1997 4A31, I am having problems, with my gear, when take off in D the car is slow, and up hill no power in 2nd & D, in Load ok. Plse advise. Thank you.
SOURCE: 1993 ford escort wagon with
Hi.
There are several things to check.
1) Check transmission fluid level.
2) Make sure that transmission is not in limp mode. That will restrict use of transmission to low gears. Go to the nearest car dealer and do a code scanning.If there are codes stored troubleshoot the codes.
3) Check if brake lights are working. Check brakes switch. The transmission shift lock may be on.
4) Check the TPS. The throttle position sensor is located on the throttle body The
sensor detects the opening of the throttle, its output is used by
the transmission control module to determine when to shift gears. The
TPS is basically a variable resistor mounted on the throttle body. The
TPS is tested by reading volts while operating the pedal. Making sure
that voltage is in range and that there are no gaps or spikes in voltage
changing while the pedal gets pressed slowly and smoothly.
5) Test the transmission switch solenoids. The higher gears solenoids may be defective. The solenoids are part of a pack located on the valve body in the transmission. The solenoids are tested reading Ohms at their terminal.
6) If you do not find anything else check wiring to transmission control module located under the dash. Make sure you did a code scanning.
7) Look for mechanical problems (clutch, valve, gears) inside the transmission.
On automatic transmission problems see also: My car does not shift..
Regards.
Ginko
Ginko.
92 views
Usually answered in minutes!
×