SOURCE: Aire acondicionado
tengo problemas con mi aire acondicionado ..al cambiar el filtro...solo tira aire caliente no enfria en lo absoluto
SOURCE: how often do i need oil change on a 2000 323i bmw?
2000 BMW 323Ci 2.5L 6-cyl Engine Code M52 B25
Engine Oil
Grade 1......SEO All TEMPS......5W-30
CAPACITIES:
Engine, with filter..........6.5 liters
2000 BMW 328Ci 2.8L 6-cyl Engine Code M52 B28
Engine Oil
Grade 1......SEO All TEMPS......5W-30
CAPACITIES:
Engine, with filter..........6.5 liters
Service every 3,000 city 5,000 hyway miles.
SOURCE: 2000 BMW 323I WONT UNLOCK WITH THE KEY OR KEY FOB,
I had same problem. Driver door would lock/unlock with key in keyhole in door, but not with fob, and other doors would not lock/unlock. Even once inside none of the doors would lock/unlock with lock switch, or even by pulling handles. Mechanic (very trustworthy) explained I needed a new control module (cost me $600). Good Luck. $600 is better than having to roll down the windows so Grandma can Luke Duke it outta the car.
SOURCE: I have the check engine code 1624 on my 2000 BMW
P1624- Pedal Position Sensor Potentiometer Supply Channel 1 Electrical.
The Siemens MSE43.0 Engine mamagement module is used on more than one model. The different meanings of the P1624 are based on your model.
The P1624 referenced here is for the MS43.0 engine management module with a note for M52 engines (323 / 328) that it is a coolant temperature below thermostat regulating temperature. You should have a M52 engine.
The MS42.0 engine mangement does not list a P1624 code in the Bentley manual.
The fault above cold be set due to the following:· Break/open in the wiring from the DME to the throttle motor(MDK).· The actuator or potentiometers inside the MDK could be contaminated.SOLUTION:
(If any of the faults listed are set) · Using a breakout box check for an open or short to ground in the wiring from the DME to the MDK.· If the wiring is intact then replace the MDK, then the adaptation values in the DME must be
cleared. Failure to do this will result in reoccurring faults.· Switch the ignition off for 30 seconds.· Turn on the ignition and delete the DME adaptations and the fault code
memory · Press the accelerator pedal to wide open throttle(WOT)4 times
MDK- motor driven throttle valve.
163 views
Usually answered in minutes!
×