How is the idle speeded up on a 2000 pontiac montana 3.4 engine

SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana

On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.

SOURCE: changing sparks plugs in a 2000 pontiac montana

remove the ignition coil pack ( 2 10mm bolts on front of it and 2 13 mm nuts on the back side) u will need a long extension and deep socket for the back ones , and unplug all electrical connectors and remove it from the vehicle and you should be able to reach the back plugs without a problem.

Michael Thomas

• 3056 Answers
• Posted on Jan 17, 2010

SOURCE: need a serpintine belt routing diagram for a 2000 pontiac Montana

Hello there: here it is

SOURCE: Where is the starter on the 2000 montana

Fowwow the large red wire from the battery and it will lead you to it. It will be on the lower part of the engine near the flywheel.

SOURCE: where is the water pump located on the 2000

here you go.