My turningsignals sto working along wth my flashers an it dont show anything on my dash lites that their on or trying or make a sound of working but everything else works fine, what is the problem an how do i fix it an where is it at

The signal wire going to the right front has a splice for the dash indicator, a wire branching off from the turn wire and going to the dash. It sounds like that right signal wire is broken or lost a connection before it splices off to the dash, so the problem sounds like it is under the dash, either coming out of the turn signal switch to the flasher or from the flasher to that splice. You may need a multi-meter to check voltages on that wire at various places under the dash. Ascertain which color wire you need to concentrate on. Check for voltage on it with key on and right blinker on-voltmeter will spike to battery voltage, then fall to zero as the flasher breaks voltage continuously, if checked after the flasher. If checked when leaving the turn switch, it should be a continuous signal on that wire. Think you better find a wiring diagram to find the right wire to check. Good luck.

Not real sure but have you tried changing out the flasher relay?

you need a turn signal switch. i know it sounds wierd but thats what controls it all for the rear of the truck also very common in chevy products

if both do not work I'd check the flasher unit first or look for a blown fuse (by the passenger side left knee, behind the cover on the console.) The flasher unit is behind the bolster cover above the driver's knees.

I would try another flasher relay if it is a 4 connector type. Usually that or a bad ground connection somewhere.

Check the FLASHERS unit

there is a short in your liting system
e

try replacing the flasher relay ,,id say thats the problem,,,should be under the dash,,drivers side,,,and it might say flasher on the unit maybe ,,,,,,also thinks it 4 pin when you pull out the plug,,

Did you check the fuse?

it is inside, under dash, on left side is a plastic sound protector, mine had 3 screws holding it up, drop this down and straight in you will see a 1" round thing - this is the flasher, pull it out and replace with new one (there are two flat prongs that plug in). It appears this is a well guarded secret!