Where is the crankshaft sensor located on a 2005 2.4L Dodge caravan

SOURCE: 04 Dodge SRT 4 crankshaft sensor

The Crankshaft Position Sensor is located directly next to the starter.

1. On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
2. Remove the Structural Collar
3. Unlock and disconnect the electrical connector to the crankshaft position sensor.
4. Remove the crankshaft position sensor bolt.
5. Remove the sensor

SOURCE: 1997 Dodge caravan crank position sensor

it is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine.

mike loshbough

• 1011 Answers
• Posted on Jan 30, 2009

SOURCE: Crankshaft position sensor location - 1991 Dodge Dakota 5.2L

it is on the passenger side on the back off the motor.there are two allen head bolts or 13mm.it goes into the transmission and normally has rubber at the opening.you should be able to gets this from the top follow middle of valve cover on pass. side the go strait back toward the fire wall.please rate this answer.

SOURCE: crankshaft sensor

2-0L-2.4L I-4 crankshaft sensor mounts to the engine block, behind the alternator, just above the oil filter. 2.5L V-6 crankshaft sensor mounts to transaxle just below the distributor.

SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?

it is located on the right side of the motor, in the trans area. Actually in the bell housing.