2002 Mazda Protege Std Trans and I put another ECM
SOURCE: 2001 mazda protege will not start
well, with all that you have changed the only two possible things that are left PCM and the ECM....
Do you have an alarm system on this vehicle? If you purchased this car second hand it may have something that is inhibiting the engine from firing. From what you have told us here that would be where I would start looking.
I really hope this is helpfull
SOURCE: Where is the ignition coil pack located on 2002
The ignition power pack and (aka ignition coil) is located on the 2004 Mazda MPV at the end of each spark plug wire on top of the spark plug. The front ones are easy to replace and all 3 can be done in about 30 min. The back ones are another issue. I had to take off the intake manifold on the top of the engine to get to them. This was about a 5 hour job. The installation of the new unit is pretty simple once you gain access to them. you simply disconnect a clip on wire and take out one screw and reverse the process to put in the new ones. Factory units run about $80 each. You can get them at other locations in after markets for as low as $55. Good Luck.
SOURCE: where is the blower motor resistor on a 2002 mazda protege?
just remove the glove box and its right behind it just take the white pug out and the two phillips screws to remove the resistor out, replace with the new one and cool off!!!! Hope this helps
SOURCE: obd2 code p0300 on mazda protege 2002
Just had one of these with a maxima, the code is multiple random misfire, when a misfire occurs, to start is do the basics, replace the plugs, check fuel pressure, clean throttle body, and coolant is topped up. also I have seen if the O2 sensor is not working correctly is can cause a misfire, you will need a scan tool to look at what the O2 sensor is doing, o rby back probing the sensor (don't damage the O2 sensor wires). If it wires replace them as well, if it has coils they usually dont give that code if one fails, it will pinpoint that a certain coil if one fals.
SOURCE: Mazda protege rear strut replacement 02
they're underneath the plastic deck cover in the back, where the speakers are. -just a few plastic fasteners and the wire connector for the rear light, and it'll pop right off. -just did it myself this weekend
123 views
Usually answered in minutes!
×