Cannot bypass pass lock - try re-programing key.https://www.6ya.com/callphilipforhelp
SOURCE: spark plugs on 2002 Saturn vue
just completed a plug removal and install on my '02 awd v6. if you have the time and patience it's straight forward; common sense was most helpful. to gain access to the plugs, both fore and aft, you must remove, in short, everything near to, associated with, the air intake system. common tools plus a 1/4 socket, with 8 inch extension to hold a #10 star bit. these star bolts are under the rectangular plastic plate atop the intake. once you have those out, disconnect all the wiring, carefully. lift the intake out, look for plug covers, fore and aft, ignition assembly lays atop each row of three plugs. with the hands of a surgeon, remove the ignition assembly, and by golly ye shall see your reward. easy from then on.
replaced my plugs with the iridium 'honeys'; marked improvement in starting, acceleration, smoothnes, noise, and gas mileage to the value of + 3.0%. changed out the oil with mobile1 extended performance, changed transmission fluid. took a shower. time involved, 7.0 hrs. dealer be damned,,priceless!
SOURCE: 2007 Saturn Vue passlock problem
Take it back to the Saturn Dealer, it is still under warranty.
SOURCE: 2002 Saturn Vue V6 Loss of Power
Yup. The throttle body connectors have a history of failing on these cars. Replace the throttle body and the wire connectors that go to it, and you're back in business. Not terribly difficult and you can get the parts from any dealer. Saturn actually has a bulletin out on this problem but they won't cover it unless you're under warranty - no recall for this.
SOURCE: 2002 Saturn S-series Passlock needs to be reset
Try this first, it takes about 30 min to do. 30-Minute Learn Procedure 1. Turn ON the ignition, with the engine OFF. 2. Attempt to start the engine, then release the key to ON; the vehicle will not start. 3. Observe the SECURITY tell tale light. After approximately 10 minutes, the light will turn OFF. 4. Turn OFF the ignition switch, and wait 5 seconds. 5. Repeat steps 1 through 4 - two more times - for a total of 3 cycles of 10 minutes. 3x10 = 30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch turn from OFF to CRANK Important: Turn the Ignition Switch OFF. The vehicle learns the Passlock Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle. 6. Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password. 7. With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles. Without a scan tool you may have momentary starter interruptions while history clears itself. Good luck and hope this helps, keep me posted, be glad to help
SOURCE: 2002 Sayurn vue 3.0L
Under the intake manifold, it will need to be removed. Not too hard to do for the average diy but recommend buying a repair manual as a guide. you will need a 1/4" drive T30 torx socket with a long extension one of the bolts is hidden but the others are under the black cover on the top of the intake. you will also need to remove the coil pack held on with torx bolts. 8 or 10 inverted torx socket needed for that.
648 views
Usually answered in minutes!
×