Jeep liberty power windows ****!!!! Tired of repairing windows!!!

check and inspect c/v axle upper and lower ball joints --upper lower control arms --hub --

Check the lockout switch for the windows. There is a lockout switch on the drivers door that will turn off all window functions in the car. Even the drivers controls.
Also after you have rulled that out, then try the window switches on each individual door.
If nothing is still working, I would try replacing the drivers switch assembly first. They are known problems. Just pay and change it. Be sure. Life is better this way.
Then change the motors in the doors if this does not cure it.
Also change the power lock motor in the failed door.
This will restore you to normal. Ebay is full of quality parts for your Jeep. I buy mine there on Ebay.

Try starting in neutral. Gear sensor may be heating up and not registering park.

HI there your problem is the motor . each window has it's sprat
motor . to be shore check the switch by remove it from console .
and with a test light
find the wires cumming out of the switch for driver side door window
see if you have power . you should have power on one wire all
the time with ignition switch in the on bastion .if you have power
as you operate the window switch .put the window is still not going
up or down you need window motor.

good luck re post if you need more help OK

2005 jeep liberty,the key will not unlock the driver side door and the power lock will not unlock the driver sider door.

there is a master fuse under the hood that controls many things check to see if one is blowen out

There are broken wires in the wiring harness between the frame and your driver's side door. These wires control all the windows and door locks in a 95 Jeep. Same thing happened to me. You will have to cut the rubber boot to get it off and check which wires are broken and repair them.

its the window regulator. not to bad to change. just a couple of screws to remove the door panel. peel the liner back & remove the 6 10mm bolts and uunhook the electrical connector and the window from the regulator. installation is reverse

the window regulator needs to be replaced