What does the code sc12 and sc41 mean on an articat 700 h1 2009

Code 700 is a generic code that means a problem has occured with the transmission control module, and code 760 is for a shift solenoid failure.
The shop would use a repair manual to test the circuit for the shift solenoid. If the solenoid is faulty, it would need to be replaced and the module reset.

Check your fuses or the stator.

Code 700 means you have a problem with the transmission or the control module. Code 340 is for the cam sensor for bank one.
Code 841 is for a problem with the low reverse pressure switch and that probably also set the 700 code.
Code 1776 is brand and sometimes model specific, generally speaking it is for a timing or ignition issue which could be connected with the 340 code.
I would clear the codes, drive the car, and see how many codes are reset again. Then go from there.

That mean you have problem with transmission.

Code 731 is for a problem with the gear ratio for first gear.
Code 700 is a general fault code that means you have a problem with the transmission control module or the transmission.
The 731 code can cause the 700 code, and the problem could be a speed sensor inside the transmission. The computer does not like the signal being sent from the transmission to the computer.

Probably a bad coil. Hopefully this helps.

The code 700 is a notice that there is a problem with the trans control module, and code 1776 could be a problem with the low-reverse solenoid inside the trans. Code 1776 can trigger the code 700.
The solenoid would need to be tested.

700=TRANSMISSION CONTROL SYSTEM, NEED TO READ TRANSMISSION DTC's ON THE DRBIII(R)
732= TRANSMISSION.....POSSIBLE CAUSES----RELATED DTC'S PRESENT, TRANSMISSION SOLENOID/PRESSURE SWITCH ASSEMBLY, INTERNAL TRANSMISSION, INTERMITTENT GEAR RATIO ERRORS..
Hope this helps ??

P0 700 is a transmission control malfunction and P1684 is a indication that your battery was disconnected within the last fifty states.However what is puzzling is your PO 700 is a generic code your P1684 is a dedicated Chrysler code your cars computer should only store one or the other not both.