If all bolts are removed some hubs are to harder to remove soak entire hub to housing with wd 40 or equivalent inside bolt hole also let sit 20 minutes and smack it pretty hard.
If still not working rent a axel puller slide hammer attach and pop out hope this helps
Secure car with jack stand take lug nuts off tire that trying to remove get good size about two pound will hit tire should pop lose don’t hit rim hope it helps or try mule kick it works for me
SOURCE: Broken Lug Studs
You have to remove the hub to remove the bolts, if they won't come out by rotating the hub.
To remove the hub, take the cap off at the center of the hub (the cap would be poking you a the center of the hub, and is about 2 inches in diameter.
There should be a cotter key or something preventing the spindle nut from turning. Remove it. If there is a cover over the spindle nut, remove it. Take the spindle nut off. Pull lightly on the hub, and it will come off. Watch for the front bearing to pop out.
To reassemble, put hub back on spindle, put bearing and washer against bearing, thread on spindle nut and tighten while rotating hub. Back off 1/2 to 1 flat add cover (if used) and install cotter key.
SOURCE: 1990 Sentra How it remove and replace lug studs on front wheel
there is a large nut that holds that hub on. Remove the cotter pin and the cap from the bolt... remove the bolt and the hub comes off.
Robert
SOURCE: trying to replace broken lug studs on 1998 honda
you have to drop the balljoints and tie rod ends..essentialy on the 92 the whole brake system.
SOURCE: I am trying to replace
With adrift punch. bang out broken stud from huB. Will take some severe hammerering, so using a heavy short handle sledge is advised. Now place the new stud into the hub hole. Put the lug nut on , TIGHTEN ( preferablly with an air impact gun ) as tight as you can till the stud bottoms out. Then you're done. Hope this helps
69 views
Usually answered in minutes!
×