Question about Cars & Trucks

Open Question

2000 chevy cavalier is there a trunk release switch? If so where is it?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1997 Chevy Cavalier i cant find the trunk release button

My trunk release on my '97 is on the floor next to driver's seat. I am driving fine at 193,000.

Posted on May 26, 2009

Ad
  • 290 Answers

SOURCE: Chevy Impala 2007 trunk lid release

Fold down rear seat and climb in the trunk....there is a manual release at the center of the trunk lid. (mandated by the government to kids don't get trapped in the trunk).

Posted on Jun 08, 2009

Mickgiever
  • 146 Answers

SOURCE: 2001 Chevy Cavalier Trunk won't shut

It may just be the latch is worn out. They can be replaced.

Posted on Jan 04, 2010

ZJLimited
  • 17970 Answers

SOURCE: replace a fuel pump on 2000 chevy cavalier

REMOVAL & INSTALLATION
(see Figures 1 and 2)

CAUTION The fuel injection system remains under pressure, even after the engine has been turned OFF. The fuel system pressure must be relieved before disconnecting any fuel lines. Failure to do so may result in fire and/or personal injury.

  1. Relieve the fuel system pressure using the recommended procedure.
  2. Disconnect the negative battery cable.
  3. Drain the fuel tank, then remove the fuel tank from the vehicle.
  4. While holding the modular fuel sender assembly down, remove the snap-ring from the designated slots located on the retainer.

WARNING The modular fuel sender assembly may spring up from its position. When removing the modular fuel sender from the tank, be aware that the reservoir bucket is full of fuel. It must be tipped slightly during removal to avoid damage to the float.
  1. Remove the external fuel strainer.
  2. Detach the Connector Position Assurance (CPA) piece from the electrical connector and detach the fuel pump electrical connector.
  3. Gently release the tabs on the sides of the fuel sender at the cover assembly. Begin by squeezing the sides of the reservoir and releasing the tab opposite the fuel level sensor. Move clockwise to release the second and third tabs in the same manner.
  4. Lift the cover assembly out far enough to detach the fuel pump electrical connection.
  5. Rotate the fuel pump baffle counterclockwise and remove the baffle and pump assembly from the retainer.
  6. Slide the fuel pump outlet out of slot, then remove the fuel pump outlet seal.

To install:
  1. Install the fuel pump outlet seal, then slide the fuel pump outlet in the slots of reservoir cover.
  2. Install the fuel pump and baffle assembly onto the reservoir retainer and rotate clockwise until seated.
  3. Install the lower retainer assembly partially into the reservoir. Line up all 3 sleeve tabs. Press the retainer onto the reservoir making sure all 3 tabs are firmly seated.

Gently pull on the fuel pump reservoir from retainer to assure a secure fastening. If not secure, replace the entire fuel sender.
  1. Attach the fuel pump connector.
  2. Fasten the CPA connector to the fuel sender cover.
  3. Install a new external fuel strainer.
  4. Install the modular fuel sender.
  5. Install the fuel tank in the vehicle.
  6. Connect the negative battery cable.
  7. Pressurize the fuel system and verify no leaks.
35a484a.jpg

Fig. 1: The module fuel sender assembly is mounted in the fuel tank

fbd4d43.jpg

Fig. 2: Modular fuel pump component identification




Hope this help to solve your problem (remember comment and rated this).

Posted on Apr 25, 2010

Gozer
  • 435 Answers

SOURCE: 2000 Cavalier: Spark plug gap for a 2.2L Chevy Cavalier 2000...

The plug gap is .040

Posted on Jun 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a trunk release button on a 93 Chevy Cavalier?


If it was added, these were options only on the Cavaliers, it would either be in the glove box as a yellow button in the upper left hand corner or on the floor near the front of the base of the driver's seat. Some models only came with a trunk release on the key fob as well.

Nov 02, 2015 | 1993 Chevrolet Cavalier

1 Answer

2004 Cavalier: 2004 chevy cavalier i opened my trunk with the fro...


check the latch on the truck lid looks like an upside down u and not like there is a bar in the way. if it looks like a bar in the way then pry it down and left to make the u shape and shut the trunk

May 17, 2010 | 2004 Chevrolet Cavalier

1 Answer

I have a 1989 chevy cavalier and my key doesnt open the trunk and i cant find a manual release


either located on the rear quarter panel behind the trunk interior cover or between the two rear speakers in the trunk area

Mar 26, 2010 | 1989 Chevrolet Cavalier

1 Answer

I need to replace the tail light bulb on my car


there are black plastic nuts inside the trunk that will unscrew off that will release the tail lamp for removal

Feb 06, 2010 | 2000 Chevrolet Cavalier

2 Answers

Cant find there trunk release button or switch for my 1998 chevy cavalier. I just need to know where the lever/button is located in the cab. I feel silly asking this but my last car was on the floor on the...


A trunk release button is not included in most cavalliers. The cavalier came standard with electronic trunk release from the keyless entry keyring. Otherwise you need to use the key.

Jan 29, 2010 | 1998 Chevrolet Cavalier

1 Answer

The emergency trunk release got pulled in my chevy cavalier and now my trunk wont close


The release needs to be reset manually. Consult your owner's manual for instructions.

Sep 12, 2009 | 2004 Chevrolet Cavalier

1 Answer

Trunk latch wont hold shut on my 02 cavalier


Make sure it is not binding/sticking where you pull the release cable.

Drench the entire works in WD-40. Push it back and forth until it moves with no resistance.

Make sure the part that hooks onto the latch hasn't come loose enough to not slide over when it makes contact.

If that doesn't work, take the whole thing off. You'll have to anyway to replace it. Chances are with it disassembled you'll see what's wrong.

May 24, 2009 | 2000 Chevrolet Cavalier

2 Answers

1997 Chevy Cavalier i cant find the trunk release button


oppen glove box , the button is there. get window button from wrecker. and yes they last very long. Vitally

May 22, 2009 | 1997 Chevrolet Cavalier

2 Answers

Is there a place inside the 2000 Chevrolet Cavalier z24, where you can open the trunk ? I have searched everywhere and can not locate it. I do not have a remote trunk opener.. So the only way as of now to...


Look at the trunk lock itself and see if there is a cable or wire going to it. cable type is generally part of the gas cover release. electric type can be anywhere (look in the glovebox first.) If there is no cable or wire you don't have a second release.

May 04, 2009 | 2000 Chevrolet Cavalier

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

21173 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...