SOURCE: torque specifications for 1998 ford ranger
Okay...here is a list since no motor size:
2.5L----- 56-64
3.0L----- 56-64
4.0L----- 59
5.0L----- 75-85
All in ft lbs.......this is for the flywheel.
SOURCE: head bolt torque for a 1996 ford ranger 2.3liter
it is in the haynes repair manuel and chad is right
SOURCE: how take off pins not bolts on caliper 87 Ford Ranger front brake
The pins / wedges just tap out use a scewdriver on the metal edge of the pin just tap it out to the rear and when putting them back in just tap them back in from the front. You will see they are diamond shape and metal cased around rubber very easy to do just take your time.
SOURCE: i need the engine torque specs for 99 chevy malibu
99 chevy malibu v6 3.1 engine, head bolt torque is-- 98 through 2001 is step1- 37 foot lbs, step 2- rotate an additional 90 degrees (1/4 turn). the rocker arm bolts are 168-in. lbs.
SOURCE: i need torque specs on a 1997 ford ranger
I'm assuming you mean for the cylinder head. This tightening sequence starts in the centre, top to to bottom, and then from one side (1 bolt) than to the other side of centre another bolt. Basically you will work in an X patterm one bolt at a time after the 2 centre bolts are tightened. Keep in mind that new head bolts MUST be used. These are called "torque to yield" bolts and permantly stretch during initial install. So, 1. 51 ft lbs and 2. 90-100 degrees. I've done this a long time and basically if you do not have a degree adapter for your torque wrench, it works out to be about 70 ft lbs. Let me know if you need anything else.
643 views
Usually answered in minutes!
×