SOURCE: 1988 chevrolet s10 blazer 2.8l 4 wheel drive
Well you can buy a new & cheaper car or either you can try to replace the head gasket.
SOURCE: 1984 s10 2.8 manual trans. flywheel causes engine to vibrate
no should be same engine. check your engine mounts and tranny mount. how bad a vibration? sometimes after installing engine the trans gets shifted around and if mount was worn it will allow it to hit crossmeber and vibrate.
SOURCE: easy way to replace starter on 97 blazer s10
I need to change the starter on a 97 Blazer s10 4wd . it a v6 vortex engine. What is the esiest way without jacking up the engine.
SOURCE: how to change an intake manifold gasket on a 2001
I suggest buying a haynes or chilton manual for your truck it will give you step by step instructions.
SOURCE: Is there ANY way to change the oil pan gasket on a S10...
Remove motor mount bolts and rear transmission crossmember bolts or nuts,suppport engine/trans. see if u have enough clearance between pan and axle remove pan. if not, split the exh away from the manifolds. worth a try
28 views
Usually answered in minutes!
Yea Rick got it a few years ago for 800.00 all the maintenance receipt were there the guy said the 4 wheel drive didn't work but it was just the vacuum line off the accuator was spli. I fixed it and everything was good until it got hot and I think blew a head gasket.no rush cause it's from Arizona
×