Question about Honda Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Odd starting problem
hi from uk not sure on your model but if your ignition has ballast resistor ie main ign circuit voltage for running is lower 9volt??? say but for a boost start 12 volts is applied when ignition key start position turning engine over ? ok so far ? your problem may be that the ballast (boost 12v ) circuit has failed this results in how when you have ign on it will start as you release starter and engine still has momentum? datsuns use to suffer with this type of ign but with the opposite effect ie car would fire/ attempt to start on key start but stopped when starter was released their ballast resisror was on n/s inner wing and looked rectangular porcelin block with a coiled resistor wire in side for reducing voltage these used to burn out check h/book on ign system ? hope this is of some help ?
Posted on Nov 20, 2008
It is most certainly the "main relay". It's a small gray (sometimes brown) plastic box tucked up behind the left dash vent. It controls the fuel delivery. It's secured with 10mm on top of your cruise control computer. It would be visible with a flashlight if you lay your head on the floor (with your head almost touching your gas pedal, seriously). Unbolt it, unplug it and then carefully pry of the plastic cover. If you have good eyes or look really CLOSE you'll see the cold solder pin (broken connection). The break will be thinner than a human hair. Heat that pin up with a soldering gun and watch it puddle back into shape to make the connection and you're good for another 100k miles :)
Posted on Dec 13, 2009
Check your main relay. It powers the fuel pump and the ignition system. They are a known problem, with a high failure rate, on the 90-93 accords. I do believe it's worth checking.
Posted on Nov 05, 2010
Testimonial: "thanks so much. I'll tell my 'mechanic'!"
Also try the crv recall replacing the ignition mechanism where you insert the key. I have the same problem and was solved after reading about it in one blog.. it is free. It appears that it got shorted and will automatically kill the engine. after a while it will be cold again and you will be able to start the engine..
Posted on Nov 07, 2010
Tips for a great answer:
Apr 04, 2014 | 2004 Chevrolet Impala
Nov 18, 2013 | 2000 Renault Laguna Estate
Feb 09, 2013 | 2000 Mazda Protege
Theft Deterrent Fuel Disable Signal Received
Perform the Powertrain Onboard Diagnostic System CheckPassword Learn Procedure - Attempt to start the vehicle (leave the ignition "on"). The Theft System telltale will flash for 4 seconds and then remain "on" for 10 minutes. Theft System Learn Mode will display Disabled on the Scan ToolTurn the ignition "off" after the Theft System telltale goes "out".Repeat steps 1 and 2 two more times. After the Theft System telltale turns "off" on the 3rd key cycle, and Theft System Learn Mode will display Enabled on the Scan Tool, attempt to start the engine. Once the engine starts the password is learned.
Oct 27, 2012 | Cars & Trucks
Apr 04, 2011 | Nissan 300ZX Cars & Trucks
Mar 13, 2011 | 1997 Pontiac Grand Am
Apr 10, 2010 | 1997 Pontiac Sunfire
Jul 26, 2009 | 1999 Saturn SL
21 people viewed this question
Usually answered in minutes!