Question about Cadillac Cars & Trucks
How do I remove the plastic lens from courtesy light-rear quarter arm rest?
Usually a small flat screw driver will work for removing the plastic cover, but you must be careful as the plastic gets quite brittle over time and is very prone to crack. There are just small tabs that hold the cover into the metal bezel.
Posted on May 20, 2019
Testimonial: "Thank you! Just as I thought . . . now I'm terrified!"
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
o2 will not make your car do that you have other issues check for secondary ignition miss or primary ignition miss sounds like you are dropping a cylinder dumping raw fuel to contaminate 02 sensor find the real problem to fix your light
Posted on Nov 22, 2008
take off the cover and replace them. if you have a volt/ohm meter you can put if on the car side and make sure you have voltage and the ohm meter on the buldb should give a 1 rating if its good. it would be the cheapest and easiest to just get a new bulb and see if it works then start checking fuses if its not the bulb.
Posted on Mar 31, 2009
You will have to pry off the lens CAREFULLY using a small screwdriver. There are two little plastic protrusions on each long side of the lens which fit into the casement. You can ease the casement away from the lens enough to get it to pop out. Re-inserting it is the same, but probably easier.
Gently, give it a try.
Hope this helps you.
Posted on Oct 23, 2009
remove ac vents with flat head screwdriver . thair should be a 7mm bolt in each vent holding tha dash pad on remove them. remove the trim going to head liner from the dash pad. use a 7mm to remove the bolts holding the cluser in place should be one each side and 3 across the back . disconnect the wiring harness and your done. also disconnect the negative batery cable when doing this
Posted on Apr 03, 2010
Tips for a great answer:
Jun 06, 2018 | Cars & Trucks
Dec 04, 2017 | Cadillac Cars & Trucks
Sep 24, 2012 | 1976 Cadillac Eldorado
Oct 02, 2010 | 1976 Cadillac Deville
Oct 02, 2010 | 1976 Cadillac Eldorado
Apr 22, 2010 | 2000 Ford Expedition
Jan 22, 2010 | 1997 Cadillac Eldorado
Dec 09, 2008 | 1988 Cadillac Sedan DeVille
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: