What year is it ? replace front turn signal ??? You mean the bulb . You may need to remove the headlamp assemble an the bumper cover .
SOURCE: Replacing front turn signal bulb on 2006 Cadillac SRX
wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.
SOURCE: I need to change the left front turn signal bulb
hi Paul
Should be able to open the hood remove plastic headlight cover & pull pins (2) on light assembly whole light assembly will pull out then replace turn signal.
Good luck.
SOURCE: How do I replace the fuse for the front turn
It is not something as easy as it sounds. We have had this happen twice in the past year. We live in Texas and everytime we have to get a new inspection sticker we have to pay someone to fix it so that it passes the inspection. It only lasts for a short time and then goes right back out. This car is a piece of ****. The system stability system warning is coming on.. have read lots of complaints. cadillac needs to recall this before someone gets killed.
SOURCE: Need to replace front turn signal bulb on a 2004
need to remove front wheel and panel from the inside.
SOURCE: how do i replace the fuse for the front turn signal on 2006 cadillac srx
The socket is defective?? Probe the socket with a volt meter to see if voltage is turning on and off to trigger the bulb to flash.
62 views
Usually answered in minutes!
×