Question about 2007 Toyota Corolla

Open Question

Where will I find the starter relay on my Toyota corolla2007 model 14i

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i check a opel corsa 14i 1998 models fault light codes it doesnt have a 10 pin plug its got a 16 pin plug


With a scanner, or take it to the dealer, and they have the TECH2 to check it for you. bridging the wrong pins might fry the ECU.

Dec 11, 2014 | Opel Cars & Trucks

1 Answer

Where is the starter relay on my 1993 Toyota Tercel?


The starter relay(s) on the Tercel are under the dash on the passenger side; easily accessed by removing the kick panel and the glove box and panel as an assembly; panel held in place by 4 ten mm screws. Some models have only one starter relay and some have 2.

If you have 2 they are on the same bracket, are identical part numbers and are both labeled Toyota starter relay; they are light green from the factory.

Aug 06, 2013 | Toyota Tercel Cars & Trucks

1 Answer

1992 Toyota Celica GTS with a starting problem. it will not start when you turn the key. the Alt has been replaced, Starter Relay and Ing. Switch but still will not start. The wire to the starter from the...


Many Toyotas have a problem with the large copper contacts in the starter solenoid.They get burnt and if they weld together, you'll have to take the battery cable off the battery to stop the starter.Pull the starter them remove and take apart the solenoid to find the contacts.Toyota does not sell solenoid contacts.Find a starter and alternator rebuilder in your area.I used to buy them for a buck a contact.

Dec 03, 2017 | 1992 Toyota Celica

1 Answer

How to replace a starter for a 96 toyota 4runner, 4wd, 6cyl


  1. Connect the battery ammeter to the starter as shown in the illustration.



0900c15280060948.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 4: Make the connections to the battery, ammeter and starter as shown here

  1. Check the rotation of the starter, it must be smooth and steady with the pinion gear moving outwards. Compare the ammeter reading to the starter specifications chart.

REMOVAL & INSTALLATION

See Figure 5
Replacing the starter while the engine is cold is recommended. A hot engine can result in personal injury.
  1. Disconnect the negative battery cable.
  2. Remove the nut and disconnect the battery cable from the magnetic switch on the starter motor.
  3. Disconnect the remaining electrical connections at the starter.
  4. Remove the nuts and/or bolts securing the starter to the bell housing, then pull the starter toward the front of the vehicle to remove.

To install:
  1. Insert the starter into the bell housing being sure that the starter drive teeth are engaged with the flywheel teeth, not jammed against the flywheel.
  2. Tighten the attaching hardware to 29 ft. lbs. (39 Nm) and replace all electrical connections.



0900c15280060949.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 5: Exploded view of a common starter mounting found on Toyota trucks

  1. Connect the positive battery cable (starter wire) to the starter.
  2. Connect the negative battery cable.

RELAY REPLACEMENT

See Figure 6
The starter relays on most of your Toyota trucks are located either in the relay block in the engine compartment or on the driver's side junction block. The cover for the relay compartments should be marked, "starter'' or the relay will have a part number with a suffix of 28300-XXXXX. Simply locate the relay, pull it out, and install a new one if needed.


0900c1528006094a.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 6: The relay may be located in the driver's side junction block or in the engine compartment relay block

Feb 05, 2011 | 1996 Toyota 4Runner

2 Answers

The starter on my 1998 4cyl toyota tacoma is stuck in the on position. The only way to shut it off is to disconnect the neg battery cable.


remove the starter relay from it's socket in the engine compartment relay box and reconnect the battery cable. If the engine cranks, your solenoid has failed closed and must be replaced. If the engine doesn't crank, borrow a 4 pole relay from somewhere else in the relay box and push it into the starter relay socket. If the engine cranks, the ignition switch is shorted to start and must be rapaired or replaced. If the engine doesn't crank, replace the starter relay. If this last case is true, you can borrow the horn relay until you get a new one. Does this make sense. Let me know if you have any questions.


b975352.gif

Oct 31, 2010 | 1998 Toyota Tacoma

1 Answer

Where is the starter relay for a 1992 camry


  1. On 1992 Camry models, starter relay is located behind the center of the instrument panel.

Oct 17, 2009 | 1992 Toyota Camry V6

1 Answer

Starter relay switch not working


Maybe you were given the wrong info. They are 2 different relays.

Jun 22, 2017 | 1991 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...