You should be fine with the standard genuine Isuzu tow bar. The rear of the vehicle may be down a bit when fully loaded depending on weight of pop top. weight distribution in pop top is the key. You can fit heavy duty shockers (GAS) & air bags to rear suspension if needed for light vans. They go inside the rear spring coils. The Hayman Reece & sway bars will raise the rear & take weight off of the tow ball but this has not been tested by Isuzu & warranted. Sway bar hitch does not fit on the genuine Isuzu tow bar also. The best thing would be to talk to an Isuzu Dealer such as North East Isuzu Ute at Burton, Adelaide, South Australia to work out your best needs.
SOURCE: Front Left Sway Bar Link
The front stabilizer shaft (sometimes called a sway bar) is mounted to
the top rear of the frame and to the lower control arm. The shaft is
attached to the frame with clamps and rubber insulators and to the
control arms with insulator links.
Try http://www.autozone.com/shopping/repairGuide.htm
SOURCE: rear sway bar link
hi normally its a 15 mm spanner that goes between the link and the bar to stop it turning while on the opposite side an 18 mm socket is used to undo the nut .
SOURCE: changing 2000 ford focus sway bar stabilizer pin
are you refering to the 5/16" bolt with 4 rubber bushings? 2 on each end? If so, cut them. Everything you need will come in kit. Bolts, bushings and sleeves.
SOURCE: replace sway bar end links '97 GMC Sierra
if you put your vehicle information in at advanceautoparts.comyou can search sway bar and find parts that you need - there was someinfo missing on which sierra model you have as far as engine size andvin # match but I came to: http://shop.advanceautoparts.com/webapp/wcs/stores/servlet/partlist_Sway-Bar-Link-Kit_78_R|GRPCHASAMS__sway%20bar___
SOURCE: How to replace 2000 mercury sable sway bar links
It does require loosening of the sway bar mounting bolts. If you don't there is no way you will get this job done.Good Luck.
137 views
Usually answered in minutes!
×