is that I what you need?
SOURCE: I have engine codes p1557,& p1570 set on my 2001
P1557 is an overboost condition, poss. from sticky vanes or actuator in the turbo. P1570 is due to your immobilizer being tripped somtime in the recent past. As long as the car still starts and doesn't shut off a few seconds later this poses no problem
SOURCE: engine light 2001 vw jetta TDI
SOURCE: 2000 Jetta 1.9 TDI is reading 2 codes for electrical connecton
The torque converter clutch circuit is built onto the tranny. You can see the plugin. You can disconnect this and will be ok, Otherwise it is expensive to fix
The crank sensor sends informaiton to car's computer telling it to give power to the motor. If the crank sensor is shot, then your car probably will turn over but won't start. Or won't always start until it is completely bad and won't start at all.
You can go to autozone.com and register for free, then you will have a full free online repair manual
SOURCE: I need the cylinder head torque settings
4 steps, starting from center and doing the normal pattern. 30 ft lbs, then 44 ft lbs.
3rd step 1/4 turn
4th step addional 1/4 turn. Make sure you are using new bolts.
1,445 views
Usually answered in minutes!
×