Question about 1992 Lexus Sc 400

1 Answer

I have a 1992 Lexus sc400, how can I start it and move it around? What wires can I connect from the ignition switch to do so? That's how the previous owner had it set up but then my roommate decided to disconnect the wires and now I can't start it up. Been trying to figure this out for a month now

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Lexus Master
  • 31,219 Answers

Push it. you arent going to bypass anything

Posted on May 14, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
fastboyz

paul erickson

  • 674 Answers

SOURCE: fuel filter location

Under vehicle, driver side, below seating area, front of rear wheelwell, mounted on chassis in fuel line

Posted on Nov 11, 2008

Bob Fox

  • 21 Answers

SOURCE: ac freon

Hello,
That shows to be 1.9 to 2.2lbs of R12 refrigerant.
That would be 30.4 ounces to 35.2 ounces. That's R12. Not R-134A


Posted on Apr 04, 2009

Kelly Garvey

  • 230 Answers

SOURCE: i have 1999 lexus ls470 -- same problem -- ignition switch

Its usually NOT the lock cylinder on the 470s, its usually the housing. The cylinder is on the dash and points towards the engine. Behind the plastic dash panel (once removed) you will see it in fact sticks in an aluminum tube that goes down 2 or 3 inches, then makes 2 turns, left to attatch to the steering column, and right to attatch to the actual ignition switch. The gear and rod assembly that the cylinder attatches to that allows it to rotate the switch usually shatters in the middle and the key starts freewheeling because there is no longer any attatchment to any of the gears or springs or click points that youd usually feel as the rotational resistance. UNFORTUNATELY this is not a 5 minute job (If it was, cars would be a breeze to steal!). Youll need at least a lock cylinder housing (dealer stock em, they break all the tyme), and IF your cylinder is undamaged, change the housing (it bolts to the steering column and extends from column towards center console area where the ignition SWITCH is actually located). If your cylinder is damaged or the housing is so shredded you cant remove the lock cylinder by normal means...then youll also need the cylinder...and it will have to be recoded to the vehicle so the anti theft will allow the new keys/cylinder to start the car. If your old cylinder and keys are intact, then transfer them to the new housing and car wont even know it happened and should start up and work as normal. Some can be removed intact, some cant...depends on how yours broke.

Posted on Sep 09, 2009

iadame

Israel Adame

  • 676 Answers

SOURCE: what are the speaker sizes 1992 Lexus sc400?

The speakers on the door are 4" as well as the rear deck speakers.

Posted on Mar 04, 2010

emissionwiz

Marvin

  • 85206 Answers

SOURCE: Need to bleed air our of cooling system on 1992 Lexus SC400

The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, then fill the coolant recovery tank full and run the engine until it just starts to overheat, high end of normal zone on gauge, then shut the engine down and run cold water over the radiator core, this will self bleed the system and the coolant will be pulled from the recovery tank, repeat as necessary, never let the recovery tank run dry or more air will be pulled into the cooling systeml

Posted on May 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 92 lexsus sc400 will start but wont go into gear


Is the shifter stuck in park or it moves and nothing happens?

If you need further help, I’m available over the phone at https://www.6ya.com/expert/oscar_403cc49e0f00cda7

Apr 04, 2015 | 1992 Lexus Sc 400

1 Answer

1995 SC400 Lexus security won't shut off when battery is connected, help please!!!


If you have the OEM key, just unlock the passenger side door with the key.

Aug 31, 2013 | 1992 Lexus Sc 400

1 Answer

What does it mean if code 15 is showing on the tester on a 1995 lexus sc400


Ignition circuit 2 has a problem, check harness for continuity and load. Could be bad coil or igniter or connection, damaged wire.

Jun 08, 2012 | Cars & Trucks

1 Answer

Yesterday I had the passenger's side window motor


Disconnecting the battery will cause this. It happened on my Mazda 6 and there should be instructions in your manual.
It will be something like this:

1. Turn ignition switch to "on" position.
2. Open passenger window completely from passenger side window switch.
3. Close passenger window completely from passenger side window switch, and hold switch for an additional 2 seconds.
4. Turn ignition back to "lock" position.

May 12, 2012 | 1992 Lexus Sc 400

1 Answer

I am looking for mechanic/car restorer & Lexus enthusiast,who specializes in/or is at least very familiar with the 1992 SC400.Possibly to modify and rebuild.The car needs a thurough inspection and pro


Wish I was near, I have the same car. And i know a lot about this car. I had the car for about 9 years now. I think i touch every inch of this car, except for the tranny. If you run into any problems, post them. I will be around. GL.

Dec 17, 2017 | 1992 Lexus Sc 400

1 Answer

I have 1992 lexus sc400 and thecar wont start. There is no power period. i;ve change the altenator and battery and still no power. No dash lights ...head lights...nothing. Battery and altenator...


is your wires on the alternator good and tight? try there good luck.... wait!!!! why did you replace them? have you had them tested? it could just be simply your starter. if so go get your money back

Aug 27, 2010 | 1992 Lexus Sc 400

1 Answer

I want to remove the head light assembly on my 1992 lexus sc400


remove the 2 10mm bolts on top that you can see, then remove front part of inner fender liner you will find 2 10mm nuts. you will need a long extension. Recomend using duct tape around feneder area to avoid scratching.

Mar 21, 2009 | 1992 Lexus Sc 400

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...