So this engine should be an 6VE1, this has got shims on top of the valves. So best to go to dealer for this unfortunately. I would only recommend you do it if you are a competent mechanic.
Valve Clearance Standard Value (cold)
Intake: 0.23 mm0.33 mm (0.0091 in0.0130 in)
Exhaust: 0.25 mm0.35 mm (0.0098 in0.0138 in)
Selection of Adjusting Shim To select the correct size adjusting shim; Add the thickness of the shim removed to the measured valve clearance Subtract the appropriate valve clearance This will give the final figure, which is the thickness of the shim required.
SOURCE: I need to change valve cover gaskets. What's the
rocker cover is diff on all types of cars but the prosidier is the same, take of rocker, clean rocker with a cloth make sure before you put back a gasket that both sides has got a smooth clean dry seal put on the gasket then the rocker cover, when you tighten make sure you do all even, turn on heat up then make sure they have the same tightness, dont over tighten as you will end up haveing to do it all again
SOURCE: I had the valve cover gasket changed on my 1996
on a v6 ? Low on oil? rear cam plugs leaking? The lifters are on the end of the rocker arms and may get clogged. I have had some luck running 0w30 mobil synthetic for about a week or so with a new oil filter [Not a fram filter] and after that put 10w30 synthetic oil back in and a new filter. Check for oil leaking at other locations. If the noise is at the front of engine near water pump it may be the hydraulic timing belt tensioner.
SOURCE: I need a diagram on how to change a valve cover
your not going to find one but theres nothing to it just remove anything thats in the way then the cover.
SOURCE: what is the procedure to
3.0L Engine
FIG : Disconnect the 2 water bypass hoses and No.6 air hose
G. Disconnect the purge hose.
FIG : Disconnect the purge hose
H. Disconnect the hoses and cables.
FIG : Disconnect the hoses and cables
I. Remove the 2 bolts and No.1 engine hanger.
J. Remove the 2 bolts and throttle body bracket.
FIG : Location of the No. 1 engine hanger and throttle body bracket
K. Disconnect the engine wire from emission control valve set.
L. Using an 8 mm socket hexagon wrench, remove the 2 bolts, 2 nuts and intake air surge tank.
FIG : Intake air surge tank mounting
FIG : Left side cylinder head cover removal
SOURCE: 97 isuzu rodeo 159,000 miles
sonds like you may need a valve adjustment.
I’m happy to help further over the phone at https://www.6ya.com/expert/kenneth_3efc1f8510674f04
671 views
Usually answered in minutes!
×