Code for camshaft sensor keeps coming up changed it and still no start
SOURCE: 2001 dodge wont start
Check your coil wlre at the coil they can rot off inside the boot. Sometimes they can still make intermittant contact.
SOURCE: where crank shaft and camshaft?
Hi I have a 2002 altima and I just fixed all that stuff. The crankshaft sensor is a different sensor and located in a different place. The crankshaft pos. sensor is located in back of the motor next to the firewall maybe half way down toward the driver side. there was a few tricks to getting to it and replacing it that no one mentioned it but I got it down. I replaced it 3 or for times till I got the right one so I was able to do the whole thing in about 15 min at the end. if you still need help email me, its kinda easy once you know what youre looking for!
SOURCE: locating and replacing a camshaft sensor in a 2005 dodge neon
this is a very very simple procedure. you do not need pics. there is a sensor located at the end of the engine on the far side from the belts. at the top. it has a plug with two wires in it. just remove the two 10mm bolts un hook the plug and reverse the process to reinstall. if you have a factory intake you may have to remove it to access this sensor. just the intake tube.
SOURCE: my 2005 stratus wont start turns over but doesnt
2.4 L?REMOVE CAM SENSOR..CRANK ENGINE..MAKE SURE CAM IS TURNING..IF NOT..TIMING BELT IS BROKEN OR STRIPPED..NEW BELT SHOULD FIX PROBLEM..MAKE SURE YOU CHECK/REPLACE WATER PUMP/IDLER/TENSIONER
2.7L?REMOVE OIL FILL CAP AND SEE IF CHAIN IS MOVING..IF NOT..YOU HAVE COLLAPSED TENSIONER..YOU WILL HAVE SOME VALVE DAMAGE..LET ME KNOW IF TOU NEED MORE INFO
SOURCE: code reads P0340 Camshaft position Sensor circuit
That makes the computor think the timing is off. Replace the sensor and see if that does it. You will then have to have the code cleared (erased) or the light will come back on/stay on.
133 views
Usually answered in minutes!
×