SOURCE: 1997 dodge Intrepid: inner tie rod
To Steering Gear Bolt
90 Nm (66 ft. lbs.)
Jam Nut
75 Nm (55 ft. lbs.)
NUMBER: 19-001-01
GROUP: Steering
DATE: Mar. 23, 2001
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 19-003-00 REV A, DATED OCTOBER 6, 2000 WHICH SHOULD BE REMOVED FROM YOUR FILES. ALL REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDE PART NUMBER CHANGES AND ADDITIONAL MODEL YEAR.
WARNING: FAILURE TO ACHIEVE A MINIMUM TORQUE OF 100 NM (74 FT. LBS.) MAY RESULT IN THE ATTACHING BOLTS LOOSENING AND FRACTURING. THIS COULD RESULT IN A SUBSEQUENT LOSS OF STEERING CONTROL. BENDING THE RETAINING TABS ALONE WILL NOT PREVENT THIS.
SUBJECT:
Loose Steering
OVERVIEW:
This bulletin provides service procedures and parts information for the inner tie rod bushings.
MODELS:
1993 - **2001 ** (LH) Concorde/Intrepid/LHS/New Yorker/Vision/300M
SYMPTOM/CONDITION:
Loose feel or clunk in the steering wheel as the wheel is moved from side to side.
DIAGNOSIS:
Observe the inner tie rod to steering gear attaching point while moving the steering wheel from side to side. If there is movement between the gear and inner tie rod, perform the Repair Procedure. If no movement is evident further diagnosis of the condition will be required.
DISCUSSION:
The inner tie rod bushings have previously been serviced with the tie rod assembly. This bulletin releases the parts, service procedures, and special tool necessary to service just the bushings. Subsequent service manuals will contain the Repair Procedure.
SOURCE: tie rod problem 98 Dodge
Yes, there's a special tool called an "inner tie rod tool". It has special crowsfoot type pieces that attach to a long tube with a 1/2' drive ratchet hole in it. First, remove the outer tie rod (COUNT THE # OF REVOLUTIONS WHILE UNSCREWING IT!!) Take off the jamb nut. Take the boot off. Use the tool to remove and replace the inner tie rod. Re-install the boot, jamb nut, and outer tie rod. If you count the # of turns it takes to remove the outer tierod, you'll be able to set it back where it was enough to drive it. i still recommend an alignment though.
SOURCE: Loose inner tie rods on '97 Dodge Dakota Sport 2WD
corect size wrench should work. count the number of turn it takes to remove each unit make note and install new units using those numbers
SOURCE: torque specs. for outer tie rod ends for 2006
Tie rod end is 35 ft. lbs. Pinch bolt for the lower ball joint - 105 .I hope this helps you
Testimonial: "thanks for the help"
SOURCE: 2005 malibu maxx ball joint and lower control arm torque specs
A Ball Joint Can Usually Be Replaced Without Removing The Control Arm From The Vehicle. Place The Vehicle On Jack Stands. Remove The Shock Absorber And Install A Spring Compressor on The Coil Spring.Remove The Nut Securing The Ball Joint To The steering Knuckle And Separate The Knuckle And Then Joint. The Ball Joint Should Be Pressed,Riveted,Bolted,Or Screwed Into The Control Arm.A Service Manual Will Give The Details For The Specific Make And Model Vehicle.
778 views
Usually answered in minutes!
×