Need to locate and replace
It’s on the drivers side of the transmission I believe
SOURCE: location of speed sensor a for 99 dodge intrepid
The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.
SOURCE: 94 dodge intrepid wont start
clicking in the fusebox? And the starter could be because you need a new one. or a rebuilt. The clicking is your starter cylinoid.
SOURCE: 2002 dodge intrepid se 2.7 engine light on got
Anytime a Chrysler product of this year has a check engine light, get it to a dealer immediately. The 2.7 liter engine is notorious for oil sludging. This can be a dangerous problem that can destroy the engine.
Your problem may have nothing to do with oil sludging, and I hope it doesn't; but don't take a chance.
Google "Chrysler engine oil sludging."
SOURCE: where is cabin air filter 2000 dodge intrepid
The 2000 Dodge Intrepid is not equipped with a cabin air filter.
SOURCE: Dodge Intrepid 1996 Water Pump Replacement Needs
a timing belt. the water pump uses it to turn it and you got to take it off to change the pump anyway so you might as well get a new one.also the hydralic timing belt tensioner should be replaced at the same time just to be sure.you will need anti freeze of course as well
26 views
Usually answered in minutes!
×