Engine cut off while driving 2004 Hyundai Sonata.

I was driving my car and it shut completely off. No warning lights no engine light it just shut off. It sound like it wants to turn over I replaced the fuel pump it lasts for about a month. It shut off again without no warning while driving. Is there a reset button on a 2009 Sonata or could it be my relay fuse?

The key must be replaced with a genuine Hyundai key then programed, the key has a computer that talks to the lock, sure it will turn over but will not start,

I believe you are referring too the Accessory Drive Belt for the Alternator...See attached drawing



To Remove:

1. Raise and support the vehicle.
2. Remove the engine splash shield.
3. Rotate the drive belt tensioner clockwise to release the drive belt tension.
4. Remove the drive belt from the alternator.
5. Slowly release the drive belt tensioner.
6. Remove the drive belt from the accessory drive pulleys.

To install:

1. Install the drive belt to the accessory drive pulley.
2. Rotate the drive belt tensioner clockwise.
3. Install the drive belt to the alternator.
4. Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
5. Slowly release the drive belt tensioner
6. Install the engine splash shield.
7. Lower the vehicle....saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Is it still covered under the factory warranty ?
Did you drive it without oil ?

Vehicles Covered: Hyundai Sonata 2002-2004 (2.4L & 2.7L Engines)

In 2003, Hyundai produced two types of Sonata:
Available engines:
4 Cylinders 2.4L VIN "S", MFI DOHC - see Figures 1 and 3.
6 Cylinders 2.7L VIN "H", MFI DOHC - see Figures 2 and 3.

To differentiate between these types of 2003 Hyundai Sonatas, the VIN 8th digit (Engine Type) will either be "S" or "H" as in the table above.

To locate the Engine drive belt, jack up the vehicle & place it onto jack stands, then slide under the car (toss a cardboard mat down first), then, once under the car, remove the (plastic) engine splash shield. Once removed, the drive & accessory belts are easily observed.



Fig. 1 Accessory Drive Belt Routing 2.4L (4 cyl) Engine - Hyundai Sonata
The "COMPRESSOR" refers to the A/C compressor, and "GENERATOR" refers to the Alternator.




Fig. 2 Accessory Drive Belt Routing 2.7L (6 cyl) Engine - Hyundai Sonata
The Belt Routing on the Left is "With A/C", on the Right is "without A/C"

Inspection - Drivebelt and Accessory Belts

Inspect the drive belt for signs of glazing or cracking. A glazed belt will be perfectly smooth from slippage, while a good belt will have a slight texture of fabric visible. Cracks will usually start at the inner edge of the belt and run outward. Worn or damaged drive belts should be replaced.

Drivebelt Removal & Installation - 2003 Sonata (2.4L and 2.7L engines)

Raise and support the vehicle.
Remove the engine splash shield.
Rotate the drive belt tensioner clockwise to release the drive belt tension.
Remove the drive belt from the alternator.
Slowly release the drive belt tensioner.
Remove the drive belt from the accessory drive pulleys.

To install:

Install the drive belt to the accessory drive pulley.
Rotate the drive belt tensioner clockwise.
Install the drive belt to the alternator.
Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
Slowly release the drive belt tensioner
Install the engine splash shield.
Lower the vehicle.

Here's the best illustration I can find of the Hyundai 2.4L and 2.7L engines - the drivebelt seems to be located on the passenger side of both of these transversely mounted engines.



Fig. 3 Hyundai 2.4L and 2.7L engines - Underhood sensor locations 2002-2004 only

Glossary of Acronyms
---------------------------------
A/C - Air Conditioning
DOHC - Dual Overhead Cam
MFI - Multi-port Fuel Injection

A LITTLE MORE SPECIFIC PLEASE,

IS IT THE CHECK ENGINE LIGHT?



FROM MASTER TECH HYUNDAI.

600CCA

IGNITION MODULE