I was doing an update on my radio and accidentally opened my driver side door and the update failed now my radio isn't coming back on
Check the vehicle owners manual for the location. If you need a manual check this site.
https://www.manualslib.com/
SOURCE: Where is the door contact switch?
Hiya
Check all 4 doors to see what works and doesn't work, be sure the interior domelight switch is set to turn on automatically when any door is open as well try the radio then open the 4 doors to see if it turns off...if your driver's side door don't work as you stated then that should be the door's "at fault".
GM built the door contact switch that's installed INSIDE the door-it's located inside the door striker/jamb area...it require removal of door trim to gain access.
However, you might want to try this visual inspection:
Check the thick wire harness located between the front-left door and door sill frame to see if any wire has been disconnected/cut or tampered with by previous owner.
SOURCE: 2005 Chrysler Pacifica passenger doors have no power
If your alarm went off, it could be that someone had tried to break into your car. They most likely may have cut some of the wires inside your door with what ever device they may have been using. Look for evidence between the bottom of the windows and doors where the problem is. If not, then it is possible that your automatic window assemblies are malfunctioning. Do you hear the motors run on the windows when you go up or down with the switch? I also have a Pacifica, 2005, however no window problems yet.
Good Luck,
Ray
SOURCE: some of the controls on the drivers side door do not work
Could be a relay..
Hope this helps !!
Its below the Dashboard, on the left side of your knee. You have to use a torch & locate it from under the Dashboard, Its roughly near to the Clutch Pedal.
Here, it looks like this:
(The Black one is the Fuse box)
431 views
Usually answered in minutes!
×