My mandrill slips and causes the bit to fall out
SOURCE: transmission slips gears
Check the fluid level on level ground,normal operating temperature,trans in Park.
SOURCE: i am planning to buy a nissan maxima.but the
This wouldn't make the tranny slip. It is making abs kick on when it shouldn't. there is a faulty in the system, most likely abs system causing this. It should be broughten to dealer honestly and I am a mechanic tell you this. It may be bad pump or circuit. I would pull the abs fuse that is in the fuse center under hood most likely. This will prevent abs from locking up on your or quit working on you. Until you get it repaired
SOURCE: 2005 nissan titan slip light stays on
You checked to see what codes you may have?
Always start there,no matter what the issue with
any vehicle
SOURCE: the automatic transmission on my 1993 Diesel Dodge Ram is slipping. What can be causing this issue?
you need the trans. rebuilt they had major problems i would recomend a aux. cooler also ck. the fluid 1st
if hydraulic , a problem master cylinder ---replace it
if cable operation replace the cable --check adjustment
Instructions
Test fit a drill bit in the lock cylinder. You want a bit that is just
smaller than the cylinder. You will be using hardened drill bits to cut through
the cylinder, since ordinary bits may be damaged by drilling metal.
Lock the drill bit into the drill chuck and tighten the chuck.
production in very fast delivery! special threading taps, plug gauge
Drill a starter groove into the lock cylinder. Start the drill on a low
speed and create a groove in the end of the lock cylinder. You don't need to
create a deep hole, just enough of a groove so that the drill bit will not slip
on a higher speed.
Increase the drill speed to the highest setting and drill out the lock
cylinder. Let the drill do the work. If you force the drill into the lock
cylinder, you could burn out the rotor inside the drill motor
20 views
Usually answered in minutes!
×