Question about Hyundai Elantra

Open Question

HOW TO REMOVE CENTER CONSOLE TO ACCESS 12V OUTLET OF 2019 ELANTRE

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
tripletauto
  • 1450 Answers

SOURCE: Front and center console 12v accessory power outlets not working

look under the drivers rear seat for the rear fuse block it will be under a black box right there

Posted on Aug 25, 2008

Ad
motor1258
  • 6674 Answers

SOURCE: How to remove cupholder console on 2003 Explorer

did you try just sticking meter probe or test light probe in the hole,dead center at back for indication of power to it? Careful not to touch sides if using test light, you will blow a fuse. Steady hand.

Posted on Jan 04, 2009

GM Elec
  • 1000 Answers

SOURCE: need instructions on how to remove center console to access electric window switch.

Here is what I could find, hope it helps.
Good luck.
Regards,


REMOVAL & INSTALLATION

See Figures 1 and 2
The following procedure is a general procedure for console removal. You may have to modify or skip certain steps depending upon your vehicle.

  1. Disconnect the negative battery cable.
  2. Remove the shift knob, floor compartment door and console trim plate.
  3. Remove the instrument panel accessory trim plate.
  4. Unfasten the retaining bolts, detach the connector, then remove the console door.



0900c152800900b7.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: Remove the retainers, unplug the connector, then remove the console door
  1. Remove the seats, as outlined later in this section, in order to get to the lower rear screw(s) on the side trim panels.
  2. Remove the console side trim panels.
  3. If equipped, remove the switch pack housing with the switches.
  4. Remove the console compartment floor protector, bolt covers and bolts.
  5. Unfasten the screws mounting the console to the instrument panel and tunnel.
  6. Unclip the harness and accessory plug.
  7. Tag and detach all necessary electrical connectors.
  8. If necessary, remove any remaining retainers.
  9. Tilt the rear of the console up, then slide the front tab back out of the instrument panel and remove the console from the vehicle.



0900c152800900b8.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: Exploded view of a typical console mounting
To install:
  1. Position the console in the vehicle by placing the front tab of the console into the instrument panel slot, making sure to align the screw holes.
  2. Attach the electrical connectors as tagged during removal.
  3. The remaining of installation is the reverse of the removal procedure. Tighten the console retaining screws to 89 inch lbs. (10 Nm).

Posted on May 04, 2009

Molson02536
  • 3854 Answers

SOURCE: 2008 Dodge Gr. Caravan 115 volt outlet

If there is power to the inverter from the switch, then there is a good chance that the inverter has gone bad. It looks like your van is a year old and the inverter may still be covered under warranty. Good luck and hope this helps. Good Luck and keep me posted, Be glad to help. The other thing to, the inverter it self may have a fuse on it that may have gone bad too, but i am not sure. Start with the warranty first and we can go from there, may be one of the technician can confirm that there is a extra fuse in the inverter. 

Posted on Jun 22, 2009

  • 60 Answers

SOURCE: 12V outlet on console doesn't work and all 10amp fuses seem intac

Probably a blown fuse. Fuse panel for that is in the passenger foot well area up on the firewall. If I remember right its fuse 34? Its on the bottom row close to the right end of the row.

Posted on Aug 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2014 nissan murano 12v power outlet at Center console and Cargo Area not working.


The fuse for the console outlets is a 20 amp fuse #33 in the fuse block. There is a relay involved and a 10 amp fuse for the control side of this relay. It, the fuse, is #19 in the fuse block. Check both fuses as either can make the circuit not function.

Jul 31, 2015 | Nissan Cars & Trucks

1 Answer

12v outlet


Yes, you will have to remove console and trim cover to find it. Install lighter back in console first than connect wires back up and re-install console.

I’m happy to help further over the phone at https://www.6ya.com/expert/david_c087e4b7d13c0163

Jun 30, 2014 | 2008 Dodge Grand Caravan

2 Answers

Where is the power outlet in the 2007 pontiac montana


The front power outlet is below the tip out tray, in the centre dash console, near the floor. It may have a plastic cover installed. The rear one is located in the rear cargo compartment, on the right hand wall of the van.

Feb 17, 2014 | 2007 Pontiac Montana

1 Answer

No power in 12v power outlet, center console, 2008 subaru tribeca


Have you checked; the fuses? The power connection? The ground connection?

Jun 19, 2012 | 2008 Subaru Tribeca

1 Answer

There is no power to the 12v power outlet (front) as well as the cigarrette lighter, and cruise control on our 2006 Kia Sedona. The fuses are good. Is there a connector behind the center console that may...


Check fuses inside AND under the hood..... "cig lighter" is 15 amp...... "power" is 25 amp under the hood. Also check your power socket in the console to see if coins have gotten in there. There was a penny in mine and I blew 3 fuses before I learned to check that from another forum. Plucked it out with some gum on the end of a stick!

Sep 04, 2010 | 2006 Kia Sedona

1 Answer

1998 corvette, center console power outlet has come apart, how do you get to the underside of the console?


Open the hatch/door on the center console, pry up that plastic piece just forward of the door with a small screwdriver working from the rear, remove those 2 nuts in the recess, unscrew the door if you wish for easier handling, at the rear of the console opening there are 2 small plastic covers, pop those out and remove the 2 nuts under them, lift the rear of the console and slide it back just enough to unplug the fuel door opening button( there isn't much slack in the wiring for this button so don't pull the console back too far ). I suspect you only needed step one, but this will get the console out for easier access to the power outlet.

Jan 07, 2010 | 1998 Chevrolet Corvette

1 Answer

Spare 12 volt power outlet failure


First probe the center contact in the power outlet with 12V test and confirm power or not. ( check with ign on since some outlets might only have power with the key or engine on ) If no power and all other interior items operate, remove outlet and check connection. It might not have ever been connected since being built. It happens .

Mar 30, 2009 | 2000 Nissan Pathfinder

1 Answer

How to remove cupholder console on 2003 Explorer


did you try just sticking meter probe or test light probe in the hole,dead center at back for indication of power to it? Careful not to touch sides if using test light, you will blow a fuse. Steady hand.

Jan 04, 2009 | 2003 Ford Explorer

1 Answer

Where is the 12v power outlet in a 2007 Toyota avalon. location


In the center console, just behind the shifter. That is the in the "Limited's" case anyway.

Nov 27, 2008 | 2007 Toyota Avalon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...