If I remember correctly, the factory lights are still separate from the wigwag lights. Once the light controller is removed the factory light switch should still operate like normal. You might need to repair the wiring where the light controller was tapped into the lighting, but just like the headlights operating when the unit was a patrol vehicle.
SOURCE: 2005 Crown Vic Police Interceptor: Starts then stalls
Have you checked the fuel filter. Fuel pump will pressure up, but fuel filter could be clogged and not work without the pressure of the fuel pump.
SOURCE: Replace horn on 2006 crown vic
I believe once you have mounted the horn and connected the wire you will find that the horn wire was cut at (by) the steering coloum that the siren override was hooked to,you will have reconnect this,I hope this helps you
SOURCE: 2000 crown vic police interceptor bypass a/c clutch pulley
you can get a A/C Delete kit for a Ford 4.6 liter. the 4.6 v-8 accessory drive system is all the same. You may also be able to run a line of string around the pullys, take it to your local auto parts store and they can match it up. I recomend the kit,
SOURCE: HOw to disable drl on 2010 ford crown vic?
check your owners manual for location of relay take out relay
SOURCE: How do I know if
I suggest that you look this up and the term interceptor refers to police package as in heavy duty suspension,brakes transmission etc. http://en.wikipedia.org/wiki/Ford_Crown_Victoria_Police_Interceptor
86 views
Usually answered in minutes!
×