SOURCE: Need to replace both crankshaft position sensors 2001 Cadillac
4.6 the twocrankshaft position sensors are located on the front of the block just above and to the left of the oil filter. not hard to replace.
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
SOURCE: where are the camshaft and crankshaft position
crankshaft sensor is and the hormonic balance pulley and cam sesoor should b and the front of the motor toward the top. But to b sure u should get a book for u vehical
SOURCE: were is the crankshaft position sensor located on 2001 chevy mali
It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.
SOURCE: crankshaft sensor location on 2001 oldsmobile
. Its above the starter going into the side of the block. (front side of the engine) Disconnect the battery. Remove the starter. Remove the wIre CONNECTOR plug to the sensor. The sensor has 1 bolt holding it in. Remove the bolt, you may have to wiggle the sensor at the base a bit as you pull it out. Replace, and make sure it is pushed in all of the way. Replace the bolt, wire plug, starter, reconnect the battery.
266 views
Usually answered in minutes!
×