Https://www.youtube.com/watch?v=Ephq4WxBlOs How To Bleed Hydraulic Clutch Wrenchin Up Watch these two videos to make sure you bleed the cylinder correctly. If you have a good clutch, then the problem is the clutch disc or throw out bearing or pressure plate.
Ford never used a slant six, that was Dodge. Defective Master cylinder for the clutch. Both parts master and slave should be replaced at once.
SOURCE: 2001 Ford ranger edge. The gears won't change.
CLUTCH SLAVE CYLINDER IS IN THE TRANSMISSION GOING TO PRESSURE PLATE AND CLUTCH.YOU HAVE TO DROP TRANSMISSION TO GET TO SLAVE CYLINDER.IF CLUTCH IS LOOSE MAKE SURE BOLTS TO CLUTCH PRESSURE PLATE TO CLUTCH IS TIGHT.THAT COULD BE YOUR PROBLEM.
SOURCE: new clutch was put in a 1985 ford escort lx 6
I would definately suspect that, and also the master cylinder associated with it.
SOURCE: How do you replace the slave cylinder on a 1992 f150?
It is not usually necessary to replace the slave cylinder. Remove the cylinder and wash in metho. Exmine it for rust, pitting or grooving. If ok scuff the glaze from the cylinder walls with 320 grit w&d paper and more metho. Wash well with metho dry and fit a new kit of rubbers. Lubricate these with brake fluid ot rubber grease as you assembe. Refit the slave cylinder and bleed out the air. Job done.
SOURCE: I have a 1996 f150 4x4 5 speed v 4.9 engine that
did you bleed the slave cylinder? On the slave cylinder there should be a bleeder screw just like a brake caliper, perform the bleed procedure just like a brake, pump clutch and open slave bleeder, repeat untill all air is no longer noticed. keep master filled with fluid and top off when completed
SOURCE: i have a 1992 ford
if the transmision is semi electric could be the sensors which are inside of the oilpan.
88 views
Usually answered in minutes!
×