Http://www.championbrands.com/aera-torquespecs.pdf
You may find your torque settings on this chart.
SOURCE: cylinder head torque settings 1990 2.6L isuzu motor
From front to back is this:
7 3 1 5 9
8 4 2 6 10
First torque value is 58 ft lbs.....then final torgue is 72 ft lbs.
SOURCE: Hi I'm looking for cylinder head torque settings for a 1992 BMW 316/318 e36
BMW cylinder torque setting all models
According to my service manual as follows.
Cyl head to engine block (torx e12 M10 bolts)
Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees
Cyl head to lower timing chain cover 10nm (89in – lb)
The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.
SOURCE: 94 mazda B3000 3.0L cylinder head torque specs
Step 1 torque to 59 ft pounds
2. Loosen one full turn
3. 37 ft pounds
4. 68 ft pounds
Use torque sequence below
SOURCE: golf iv 1.6 8v cylinder head torque settings
hi to tighten you have to do it in 4 stages as follows
1st stage 40nm leave 5 mins
2nd stage 60nm leave 5 mins
3rd stage 90 degrees leave 10 mins
4th stage 90 degrees
then you are done i will try put order on here i hope this works as follows
10 4 2 6 8
front of engine back of engine
7 5 1 3 9
in that order hope this helps
SOURCE: torque settings for a hyundai accent 1500 1998
cylinder head bolt torque
52-55 ft lbs. cold engine
59-63 ft lbs. hot engine
connecting rod cap nut 26-28 ft lbs. SOHC
connecting rod cap nut 23-26 ft lbs. DOHC
main caps 41-44 ft lbs.
4,650 views
Usually answered in minutes!
×