This is a performance shift mode for the automatic transmission. It prevents the transmission from shifting into the highest gear. There should be a button near or on the shifter marked "hold". If so push it to return the transmission to normal operation. You'll get better gas mileage as well.
SOURCE: Dash board green indicator light gone to yellow why
yes what does it mean mine is green is that good
SOURCE: hold light
since this is pretty old you have probably discovered the answer. There is a button on the shaft of the shifter on the left side.....just above the level of the parking brake. When pushed it is supposed to hold the transmission in it's present gear and the dash light tells you it is on. Push it again to turn off.
Sam
SOURCE: i have a yellow light on on the dash board - what
That is most likely the check engine light. This light is to alert you that the computer has noted a fault in one of the car's systems. Take the car to an autoparts store and have them scan the computer for any codes stored. Most parts stores will do the scan for free. Getting the codes will show what the computer has identified so appropriate corrective action can be taken. Hope this helped and best wishes.
SOURCE: hold light came on on my 99 mazda millenia. what
I think there is a button on your transmission shifter that is the Hold button. you probably engaged it by accident. Its on the left side of the shifter and you need to disengage. I think it pops out.
SOURCE: What is the orange light
Hi, this is the malfunction indicator.
Please see my tip at http://www.fixya.com/cars/r5932051-check_engine_light_check. These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
Whenever
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults) as long as the light is on. You must now have the
dealer hook up a special electronic diagnostic tool and "scan"
the system for the fault code that is stored for the problem(s)
Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module
Please see my tip at http://www.fixya.com/cars/r5932051-check_engine_light_check. These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
1,769 views
Usually answered in minutes!
×