SOURCE: 92 dodge dakota wont start
I would start with the Starter check for voltage getting to the starter should read 12 volts at both terminals
SOURCE: ac clutch going out on 93 dodge dakota
If the clutch is noisy from a bad bearing then don't drive far,if the compressor clutch pulley bearing seizes up it will freeze the pulley and the belt will burn off, and you are stuck, if you mean the anything else besides this drive it.
SOURCE: 96 Dodge Ram Gas Gauge always on empty
The fuel pump and the sensor is altogether as one assembly. So if you buy the pump you would also be buying the sensor. Just for your information the pump is located in the gas tank under the bed, so you have two ways to change it. One is take the bed off (which is a lot easier if you have a full gas tank). But if its empty than use a jack to lower the tank down from underneath the truck. I hope this helps.
SOURCE: changing a clutch on a manual dodge avenger 96
Try going to http://autozone.com and see if they have some helpful information for your problem.
Thank you for using Fix Ya!
Don't forget to rate to overall satisfaction of this answer.
Good Luck!
SOURCE: Where is the neutral safety switch?
IF you have a chrysler 727 trans it's on the left rear corner of the case just above the trans pan (has 3 wires on it) If you have an asi trans, I'm not sure where they put it but I'd look around the linkage going into unit and on the other side (like jeeps have)
105 views
Usually answered in minutes!
×